[U-Boot] [PATCH 16/19] imx: ventana: add gpio setup to SPL

[Tim Harvey]

If the SPL is to be used for Falcon mode then we need to make sure it
configures basic GPIO (iomux, padconf, and default output levels).

Signed-off-by: Tim Harvey <tharvey at gateworks.com>
---
 board/gateworks/gw_ventana/gw_ventana_spl.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/board/gateworks/gw_ventana/gw_ventana_spl.c b/board/gateworks/gw_ventana/gw_ventana_spl.c
index 82078a0..cde04cf 100644
--- a/board/gateworks/gw_ventana/gw_ventana_spl.c
+++ b/board/gateworks/gw_ventana/gw_ventana_spl.c
@@ -510,6 +510,9 @@ void board_init_f(ulong dummy)
 	/* read/validate EEPROM info to determine board model and SDRAM cfg */
 	board_model = read_eeprom(CONFIG_I2C_GSC, &ventana_info);
 
+	/* configure model-specific gpio */
+	setup_iomux_gpio(board_model, &ventana_info);
+
 	/* provide some some default: 32bit 128MB */
 	if (GW_UNKNOWN == board_model) {
 		ventana_info.sdram_width = 2;
-- 
1.9.1