[U-Boot] mxs: HAB experiments

[Marek Vasut]

On Wednesday, November 18, 2015 at 10:57:13 AM, Florian Achleitner wrote:
> Hi,
> 
> On Wednesday, November 18, 2015 09:55:12 AM Marek Vasut wrote:
> > On Tuesday, November 17, 2015 at 02:16:06 PM, Florian Achleitner wrote:
> > > Hi Marek,
> > 
> > Hi,
> > 
> > > thanks for you contributions to support mxs HAB v4 in u-boot. I'm
> > > currently
> > > experimenting with HAB on my imx28 board. I think I put everything
> > > together
> > > quite well.
> > > 
> > > 
> > > 
> > > But examining the HAB event log I see two successful authentications
> > > for the u-boot.bin and the IVT followed by a FAILURE with "unsupported
> > > command" in the "CSF Context".  It is the same for both the SPL and
> > > the main u-boot. Did you see something similar? It suggests a wrong
> > > command in the CSF file, but I think there is not a lot that can be
> > > wrong in the CSF input file for the cst tool. But probably the cst
> > > output is different between versions? I use version
> > > BLN_CST_MAIN_02.03.00.
> > > 
> > > 
> > > 
> > > I use u-boot's mkimage, which can generate a signed boot stream,
> > > together with your hand-crafted IVT generator in the Makefile.
> > 
> > Can you share your CSF files (make sure to blank out the private
> > material) ?
> 
> The CSF follows. It is the same for the spl and the main u-boot.
> 
> Anyways, I currently suspect the cst tool in its current version (2.3.1) to
> produce binaries that are incompatible with the mx28 HAB Rom. However, I
> couldn't find an older version of the cst yet, so I can't try it at the
> moment.
> 
> Thanks!
> Florian
> 
> [Header]
> Version = 4.0
> Hash Algorithm = sha256
> Engine Configuration = 0
> Certificate Format = X509
> Signature Format = CMS
> Engine = DCP

I use "Engine = ANY" here, not sure if it matters.

> 
> [Install SRK]
> File = "$SRK_1_2_table.bin"
> Source index = 0
> 
> [Install CSFK]
> File = "$CSF1_1_sha256_2048_65537_v3_usr_crt.pem"
> 
> [Authenticate CSF]
> 
> [Install Key]
> Verification index = 0
> Target index = 2
> File = "$IMG1_1_sha256_2048_65537_v3_usr_crt.pem"
> 
> [Authenticate Data]
> Verification index = 2

Here I use "Engine = DCP" (missing in your example)

I am using BLN_CST_MAIN_02.00.00 btw.

Best regards,
Marek Vasut