[U-Boot] [PATCH 1/2][v2] driver: net: ldpaa_eth: Set MAC address during interface open

Prabhakar Kushwaha prabhakar at freescale.com
Wed Oct 7 12:00:13 CEST 2015


Currently ldpaa ethernet driver rely on DPL file to statically configure
mac address for the DPNIs. It is not a correct approach.

Add support setting MAC address from env variable or Random MAC address.

Signed-off-by: Prabhakar Kushwaha <prabhakar at freescale.com>
---
Changs for v2: Sending as it is

 drivers/net/ldpaa_eth/ldpaa_eth.c | 15 +++------------
 1 file changed, 3 insertions(+), 12 deletions(-)

diff --git a/drivers/net/ldpaa_eth/ldpaa_eth.c b/drivers/net/ldpaa_eth/ldpaa_eth.c
index 4de7586..99acb7a 100644
--- a/drivers/net/ldpaa_eth/ldpaa_eth.c
+++ b/drivers/net/ldpaa_eth/ldpaa_eth.c
@@ -220,7 +220,6 @@ static int ldpaa_eth_open(struct eth_device *net_dev, bd_t *bd)
 {
 	struct ldpaa_eth_priv *priv = (struct ldpaa_eth_priv *)net_dev->priv;
 	struct dpni_queue_attr rx_queue_attr;
-	uint8_t mac_addr[6];
 	int err;
 
 	if (net_dev->state == ETH_STATE_ACTIVE)
@@ -240,21 +239,13 @@ static int ldpaa_eth_open(struct eth_device *net_dev, bd_t *bd)
 	if (err)
 		goto err_bind;
 
-	err = dpni_get_primary_mac_addr(dflt_mc_io, MC_CMD_NO_FLAGS,
-					priv->dpni_handle, mac_addr);
+	err = dpni_add_mac_addr(dflt_mc_io, MC_CMD_NO_FLAGS,
+				priv->dpni_handle, net_dev->enetaddr);
 	if (err) {
-		printf("dpni_get_primary_mac_addr() failed\n");
+		printf("dpni_add_mac_addr() failed\n");
 		return err;
 	}
 
-	memcpy(net_dev->enetaddr, mac_addr, 0x6);
-
-	/* setup the MAC address */
-	if (net_dev->enetaddr[0] & 0x01) {
-		printf("%s: MacAddress is multcast address\n",	__func__);
-		return 1;
-	}
-
 #ifdef CONFIG_PHYLIB
 	/* TODO Check this path */
 	err = phy_startup(priv->phydev);
-- 
1.9.1




More information about the U-Boot mailing list