[U-Boot] [PATCH v1 12/12] rockchip: Add basic support for evb-rk3036 board

[hl]

Hi Simon,

On 23/10/15 09:34, Simon Glass wrote:
> Hi,
>
> On 22 October 2015 at 19:27, hl <hl at rock-chips.com> wrote:
>> Hi Simon,
>>
>>
>> On 22/10/15 22:08, Simon Glass wrote:
>>> On 20 October 2015 at 20:37, Lin Huang <hl at rock-chips.com> wrote:
>>>> This add some basic files required to allow the board to dispaly
>>>> serial message and can run command(mmc info etc)
>>>>
>>>> Signed-off-by: Lin Huang <hl at rock-chips.com>
>>>> ---
>>>> Changes in v1:
>>>> - clean copyright announcement
>>>>
>>>>    arch/arm/dts/Makefile                    |  3 ++-
>>>>    arch/arm/dts/rk3036-sdk.dts              | 46
>>>> ++++++++++++++++++++++++++++++++
>>>>    board/evb_rk3036/evb_rk3036/Kconfig      | 15 +++++++++++
>>>>    board/evb_rk3036/evb_rk3036/MAINTAINERS  |  0
>>>>    board/evb_rk3036/evb_rk3036/Makefile     |  7 +++++
>>>>    board/evb_rk3036/evb_rk3036/evb_rk3036.c |  7 +++++
>>>>    configs/evb-rk3036_defconfig             | 41
>>>> ++++++++++++++++++++++++++++
>>>>    include/configs/evb_rk3036.h             | 12 +++++++++
>>>>    8 files changed, 130 insertions(+), 1 deletion(-)
>>>>    create mode 100644 arch/arm/dts/rk3036-sdk.dts
>>>>    create mode 100644 board/evb_rk3036/evb_rk3036/Kconfig
>>>>    create mode 100644 board/evb_rk3036/evb_rk3036/MAINTAINERS
>>>>    create mode 100644 board/evb_rk3036/evb_rk3036/Makefile
>>>>    create mode 100644 board/evb_rk3036/evb_rk3036/evb_rk3036.c
>>>>    create mode 100644 configs/evb-rk3036_defconfig
>>>>    create mode 100644 include/configs/evb_rk3036.h
>>>>
>>> Can you also please update doc/README.rockchip with build instructions
>>> and how to get an image onto this board?
>>      I try to figure out how to merge binary blob and u-boot-dtb.bin use
>> mkimage,
>>      i will update doc/README ASAP when i finish it. And where should  the
>> binary blob store?
> Hopefully we don't need the binary block, and u-boot-spl.bin will
> contain all the code needed. There are boards already with tiny SPL
> images.
>
> Then you can just provide instructions on how to build the image,
> perhaps with the 'dd' tool. You don't need to build an entire image in
> the build system - just provide instructions on how someone might put
> the SPL and U-Boot onto an SD card and get it to boot.

     Okay, i will implement rk3036 sdram driver first, and try to run it 
in SPL,
     it may take some times.
> Regards,
> Simon
>
>
>

-- 
Lin Huang