[U-Boot] [PATCH v1 12/12] rockchip: Add basic support for evb-rk3036 board

[Simon Glass]

Hi,

On 22 October 2015 at 19:27, hl <hl at rock-chips.com> wrote:
> Hi Simon,
>
>
> On 22/10/15 22:08, Simon Glass wrote:
>>
>> On 20 October 2015 at 20:37, Lin Huang <hl at rock-chips.com> wrote:
>>>
>>> This add some basic files required to allow the board to dispaly
>>> serial message and can run command(mmc info etc)
>>>
>>> Signed-off-by: Lin Huang <hl at rock-chips.com>
>>> ---
>>> Changes in v1:
>>> - clean copyright announcement
>>>
>>>   arch/arm/dts/Makefile                    |  3 ++-
>>>   arch/arm/dts/rk3036-sdk.dts              | 46
>>> ++++++++++++++++++++++++++++++++
>>>   board/evb_rk3036/evb_rk3036/Kconfig      | 15 +++++++++++
>>>   board/evb_rk3036/evb_rk3036/MAINTAINERS  |  0
>>>   board/evb_rk3036/evb_rk3036/Makefile     |  7 +++++
>>>   board/evb_rk3036/evb_rk3036/evb_rk3036.c |  7 +++++
>>>   configs/evb-rk3036_defconfig             | 41
>>> ++++++++++++++++++++++++++++
>>>   include/configs/evb_rk3036.h             | 12 +++++++++
>>>   8 files changed, 130 insertions(+), 1 deletion(-)
>>>   create mode 100644 arch/arm/dts/rk3036-sdk.dts
>>>   create mode 100644 board/evb_rk3036/evb_rk3036/Kconfig
>>>   create mode 100644 board/evb_rk3036/evb_rk3036/MAINTAINERS
>>>   create mode 100644 board/evb_rk3036/evb_rk3036/Makefile
>>>   create mode 100644 board/evb_rk3036/evb_rk3036/evb_rk3036.c
>>>   create mode 100644 configs/evb-rk3036_defconfig
>>>   create mode 100644 include/configs/evb_rk3036.h
>>>
>> Can you also please update doc/README.rockchip with build instructions
>> and how to get an image onto this board?
>
>     I try to figure out how to merge binary blob and u-boot-dtb.bin use
> mkimage,
>     i will update doc/README ASAP when i finish it. And where should  the
> binary blob store?

Hopefully we don't need the binary block, and u-boot-spl.bin will
contain all the code needed. There are boards already with tiny SPL
images.

Then you can just provide instructions on how to build the image,
perhaps with the 'dd' tool. You don't need to build an entire image in
the build system - just provide instructions on how someone might put
the SPL and U-Boot onto an SD card and get it to boot.

Regards,
Simon