[U-Boot] [PATCH] FIX: fat: Provide correct return code from disk_{read|write} to upper layers

[Lukasz Majewski]

It is very common that FAT code is using following pattern:
if (disk_{read|write}() < 0)
        return -1;

Up till now the above code was dead, since disk_{read|write) could only
return value >= 0.
As a result some errors from medium layer (i.e. eMMC/SD) were not caught.

The above behavior was caused by block_{read|write|erase} declared at
struct block_dev_desc (@part.h). It returns unsigned long, where 0
indicates error and > 0 indicates that medium operation was correct.

This patch as error regards 0 returned from block_{read|write|erase}
when nr_blocks is grater than zero. Read/Write operation with nr_blocks=0
should return 0 and hence is not considered as an error.

Signed-off-by: Lukasz Majewski <l.majewski at samsung.com>

Test HW: Odroid XU3 - Exynos 5433
---
 fs/fat/fat.c       | 11 +++++++++--
 fs/fat/fat_write.c | 11 +++++++++--
 2 files changed, 18 insertions(+), 4 deletions(-)

diff --git a/fs/fat/fat.c b/fs/fat/fat.c
index bccc3e3..d743014 100644
--- a/fs/fat/fat.c
+++ b/fs/fat/fat.c
@@ -45,11 +45,18 @@ static disk_partition_t cur_part_info;
 
 static int disk_read(__u32 block, __u32 nr_blocks, void *buf)
 {
+	ulong ret;
+
 	if (!cur_dev || !cur_dev->block_read)
 		return -1;
 
-	return cur_dev->block_read(cur_dev->dev,
-			cur_part_info.start + block, nr_blocks, buf);
+	ret = cur_dev->block_read(cur_dev->dev,
+				  cur_part_info.start + block, nr_blocks, buf);
+
+	if (nr_blocks && ret == 0)
+		return -1;
+
+	return ret;
 }
 
 int fat_set_blk_dev(block_dev_desc_t *dev_desc, disk_partition_t *info)
diff --git a/fs/fat/fat_write.c b/fs/fat/fat_write.c
index 98b88ad..adb6940 100644
--- a/fs/fat/fat_write.c
+++ b/fs/fat/fat_write.c
@@ -30,6 +30,8 @@ static void uppercase(char *str, int len)
 static int total_sector;
 static int disk_write(__u32 block, __u32 nr_blocks, void *buf)
 {
+	ulong ret;
+
 	if (!cur_dev || !cur_dev->block_write)
 		return -1;
 
@@ -39,8 +41,13 @@ static int disk_write(__u32 block, __u32 nr_blocks, void *buf)
 		return -1;
 	}
 
-	return cur_dev->block_write(cur_dev->dev,
-			cur_part_info.start + block, nr_blocks,	buf);
+	ret = cur_dev->block_write(cur_dev->dev,
+				   cur_part_info.start + block,
+				   nr_blocks, buf);
+	if (nr_blocks && ret == 0)
+		return -1;
+
+	return ret;
 }
 
 /*
-- 
2.0.0.rc2