[U-Boot] [PATCH 2/4] spi: cadence_qspi: Fix fdt read of spi-max-frequency

[Marek Vasut]

On Thursday, September 03, 2015 at 03:42:00 PM, Chin Liang See wrote:
> Fix the fdt read for spi-max-frequency as it's contained
> in the child node. Current state of code is always
> returning default value.
> 
> Signed-off-by: Chin Liang See <clsee at altera.com>
> Cc: Dinh Nguyen <dinguyen at opensource.altera.com>
> Cc: Dinh Nguyen <dinh.linux at gmail.com>
> Cc: Marek Vasut <marex at denx.de>
> Cc: Stefan Roese <sr at denx.de>
> Cc: Vikas Manocha <vikas.manocha at st.com>
> Cc: Jagannadh Teki <jteki at openedev.com>
> Cc: Pavel Machek <pavel at denx.de>
> ---
>  drivers/spi/cadence_qspi.c |    8 ++++----
>  1 files changed, 4 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/spi/cadence_qspi.c b/drivers/spi/cadence_qspi.c
> index 300934e..a00af87 100644
> --- a/drivers/spi/cadence_qspi.c
> +++ b/drivers/spi/cadence_qspi.c
> @@ -291,10 +291,6 @@ static int cadence_spi_ofdata_to_platdata(struct
> udevice *bus) plat->regbase = (void *)data[0];
>  	plat->ahbbase = (void *)data[2];
> 
> -	/* Use 500KHz as a suitable default */
> -	plat->max_hz = fdtdec_get_int(blob, node, "spi-max-frequency",
> -				      500000);
> -
>  	/* All other paramters are embedded in the child node */
>  	subnode = fdt_first_subnode(blob, node);
>  	if (subnode < 0) {
> @@ -302,6 +298,10 @@ static int cadence_spi_ofdata_to_platdata(struct
> udevice *bus) return -ENODEV;
>  	}
> 
> +	/* Use 500KHz as a suitable default */
> +	plat->max_hz = fdtdec_get_int(blob, subnode, "spi-max-frequency",
> +				      500000);

Use fdtdec_get_u32() or such, since the value is unsigned int (have you ever
seen negative frequency ? ;-) ). Then check the fdtdec_get_u32() return value.

>  	/* Read other parameters from DT */
>  	plat->page_size = fdtdec_get_int(blob, subnode, "page-size", 256);
>  	plat->block_size = fdtdec_get_int(blob, subnode, "block-size", 16);

Best regards,
Marek Vasut