[U-Boot] [RFC] Adding support for NI Ettus Research USRP E3XX series

[Marek Vasut]

On Thursday, September 03, 2015 at 08:44:00 PM, Moritz Fischer wrote:
> Hi all,

Hi!

> this patch adds basic support for NI Ettus Research E3XX series
> boards. I tagged this RFC because I'm not sure if the boards/xilinx/zynq
> subdirectory is the correct place for this, as I'll have some follow up
> patches that read the devices EEPROM for ethernet address etc.

It's not, it should be board/ettus/e3xx/ .

> Would putting it under boards/ni/zynq be the correct way of integrating it?
> While technically a Zynq device there are a lot of custom modifications,
> that I wouldn't like to force into board/xilinx/zynq/board.c in my follow
> up patches. However duplicating the entire board.c doesn't seem like a
> good idea neither.
> 
> Any suggestions? For future reference do you want me to split out dts etc
> in a separate patch?

It's always boards/VENDOR/BOARD/ .

Best regards,
Marek Vasut