[U-Boot] [uboot] [PATCH 2/2] net: phy: ti: Allow the driver to be more configurable

[Dan Murphy]

Michal

On 04/05/2016 12:01 PM, Michal Simek wrote:
> On 5.4.2016 17:05, Dan Murphy wrote:
>> Not all devices use the same internal delay or fifo depth.
>> Add the ability to set the internal delay for rx or tx and the
>> fifo depth via the devicetree.  If the value is not set in the
>> devicetree then set the delay to the default.
>>
>> If devicetree is not used then use the default defines within the
>> driver.
>>
>> Signed-off-by: Dan Murphy <dmurphy at ti.com>
>> ---
>>
>> RFC->v1 - Added devicetree support - https://patchwork.ozlabs.org/patch/604113/
>>
>>  drivers/net/phy/ti.c | 81 ++++++++++++++++++++++++++++++++++++++++++++++------
>>  1 file changed, 73 insertions(+), 8 deletions(-)
>>
>> diff --git a/drivers/net/phy/ti.c b/drivers/net/phy/ti.c
>> index c3912d5..e91a6ed 100644
>> --- a/drivers/net/phy/ti.c
>> +++ b/drivers/net/phy/ti.c
>> @@ -6,6 +6,14 @@
>>   */
>>  #include <common.h>
>>  #include <phy.h>
>> +#include <linux/compat.h>
>> +#include <malloc.h>
>> +
>> +#include <fdtdec.h>
>> +#include <dm.h>
>> +#include <dt-bindings/net/ti-dp83867.h>
>> +
>> +DECLARE_GLOBAL_DATA_PTR;
>>  
>>  /* TI DP83867 */
>>  #define DP83867_DEVADDR		0x1f
>> @@ -57,6 +65,17 @@
>>  #define MII_MMD_CTRL_INCR_RDWT	0x8000 /* post increment on reads & writes */
>>  #define MII_MMD_CTRL_INCR_ON_WT	0xC000 /* post increment on writes only */
>>  
>> +/* User setting - can be taken from DTS */
>> +#define DEFAULT_RX_ID_DELAY	DP83867_RGMIIDCTL_2_25_NS
>> +#define DEFAULT_TX_ID_DELAY	DP83867_RGMIIDCTL_2_75_NS
>> +#define DEFAULT_FIFO_DEPTH	DP83867_PHYCR_FIFO_DEPTH_4_B_NIB
>> +
>> +struct dp83867_private {
>> +	int rx_id_delay;
>> +	int tx_id_delay;
>> +	int fifo_depth;
>> +};
>> +
>>  /**
>>   * phy_read_mmd_indirect - reads data from the MMD registers
>>   * @phydev: The PHY device bus
>> @@ -134,16 +153,58 @@ static inline bool phy_interface_is_rgmii(struct phy_device *phydev)
>>  		phydev->interface <= PHY_INTERFACE_MODE_RGMII_TXID;
>>  }
>>  
>> -/* User setting - can be taken from DTS */
>> -#define RX_ID_DELAY	8
>> -#define TX_ID_DELAY	0xa
>> -#define FIFO_DEPTH	1
>> +#if defined(CONFIG_DM_ETH)
>> +/**
>> + * dp83867_data_init - Convenience function for setting PHY specific data
>> + *
>> + * @phydev: the phy_device struct
>> + */
>> +static int dp83867_of_init(struct phy_device *phydev)
>> +{
>> +	struct dp83867_private *dp83867 = phydev->priv;
>> +	struct udevice *dev = phydev->dev;
>> +
>> +	dp83867->rx_id_delay = fdtdec_get_uint(gd->fdt_blob, dev->of_offset,
>> +				 "ti,rx_int_delay", DEFAULT_RX_ID_DELAY);
>> +
>> +	dp83867->tx_id_delay = fdtdec_get_uint(gd->fdt_blob, dev->of_offset,
>> +				 "ti,tx_int_delay", DEFAULT_TX_ID_DELAY);
>> +
> this is not aligned with the binding you sent.
> ti,rx-internal-delay
> and
> ti,tx-internal-delay

You are right I will fix it and then make the same change in the kernel

Dan

>
>
> Thanks,
> Michal


-- 
------------------
Dan Murphy