[U-Boot] [PATCH] powerpc/mpc85xx: set L2PE in L2CSR0 before enabling L2 cache

[Aneesh Bansal]

While enabling L2 cache, the value of L2PE (L2 cache parity/ECC
error checking enable) must not be changed while the L2 cache is
enabled.
So, L2PE must be set before enabling L2 cache.

Signed-off-by: Aneesh Bansal <aneesh.bansal at nxp.com>
---
 arch/powerpc/cpu/mpc85xx/start.S | 23 +++++++++++++++++++++++
 1 file changed, 23 insertions(+)

diff --git a/arch/powerpc/cpu/mpc85xx/start.S b/arch/powerpc/cpu/mpc85xx/start.S
index 82a151a..4c51225 100644
--- a/arch/powerpc/cpu/mpc85xx/start.S
+++ b/arch/powerpc/cpu/mpc85xx/start.S
@@ -720,16 +720,39 @@ enable_l2_cluster_l2:
 	ori	r4, r4, (L2CSR0_L2FI|L2CSR0_L2LFC)@l
 	sync
 	stw	r4, 0(r3)	/* invalidate L2 */
+	/* Poll till the bits are cleared */
 1:	sync
 	lwz	r0, 0(r3)
 	twi	0, r0, 0
 	isync
 	and.	r1, r0, r4
 	bne	1b
+
+	/* L2PE must be set before L2 cache is enabled */
+	lis	r4, (L2CSR0_L2PE)@h
+	ori	r4, r4, (L2CSR0_L2PE)@l
+	sync
+	stw	r4, 0(r3)	/* enable L2 parity/ECC error checking */
+	/* Poll till the bit is set */
+1:	sync
+	lwz	r0, 0(r3)
+	twi	0, r0, 0
+	isync
+	and.	r1, r0, r4
+	beq	1b
+
 	lis	r4, (L2CSR0_L2E|L2CSR0_L2PE)@h
 	ori	r4, r4, (L2CSR0_L2REP_MODE)@l
 	sync
 	stw	r4, 0(r3)	/* enable L2 */
+	/* Poll till the bit is set */
+1:	sync
+	lwz	r0, 0(r3)
+	twi	0, r0, 0
+	isync
+	and.	r1, r0, r4
+	beq	1b
+
 delete_ccsr_l2_tlb:
 	delete_tlb0_entry 0, CONFIG_SYS_CCSRBAR + 0xC20000, MAS2_I|MAS2_G, r3
 #endif
-- 
1.8.1.4