[U-Boot] U-Boot SPL 2016.09-rc1 on NTC C.H.I.P.

[Boris Brezillon]

+Glaucio who is facing the same problem but on a cubieboard2.

On Sun, 21 Aug 2016 16:14:39 +0200
Boris Brezillon <boris.brezillon at free-electrons.com> wrote:

> Hi,
> 
> On Sun, 21 Aug 2016 12:03:19 +0200
> Hans de Goede <hdegoede at redhat.com> wrote:
> 
> > Hi,
> > 
> > On 21-08-16 11:01, Marcus Glocker wrote:  
> > > On Sat, Aug 20, 2016 at 03:05:38PM -0400, Tom Rini wrote:
> > >    
> > >> On Sat, Aug 20, 2016 at 07:26:19AM +0200, Marcus Glocker wrote:    
> > >>> Hello,
> > >>>
> > >>> While U-Boot SPL 2015.10 works fine on my allwinner,sun5i-r8 board I
> > >>> face following issue with U-Boot SPL 2016.09-rc1 on it:
> > >>>
> > >>> 	bash-4.3# cu -l /dev/cuaU0 -s 115200
> > >>> 	Connected to /dev/cuaU0 (speed 115200)
> > >>>
> > >>> 	U-Boot SPL 2016.09-rc1 (Jul 31 2016 - 16:37:00)
> > >>> 	DRAM: 512 MiB
> > >>> 	CPU: 1008000000Hz, AXI/AHB/APB: 3/2/2
> > >>> 	Trying to boot from NAND
> > >>> 	### ERROR ### Please RESET the board ###
> > >>>
> > >>> Any ideas what change did cause this or where to start looking after?    
> 
> Markus, can you share your .config?
> I tested the different bits while submitting the NAND driver and the
> SPL NAND driver improvements and it was working fine.
> I'll try to test 2016.09-rc1 tomorrow.

Just tried to boot a mainline uboot on my CHIP and it boots fine [1].
Here is my .config [2], can you compare yours with this one?

Can you also detail how you flash the images?

Thanks,

Boris

[1]http://code.bulix.org/xr8n68-105114
[2]http://code.bulix.org/hft09x-105116