[U-Boot] [PATCH] i2c: mvtwsi: Fix order of address bytes (high to low)

[Stefan Roese]

Patch f8a10ed1 [i2c: mvtwsi: Make address length variable] accidentally
inverted the sequence of address bytes sent to the I2C device. This
patch corrects this by sending the highest byte first and the lowest
byte last again.

Tested on theadorable Armada-XP board.

Signed-off-by: Stefan Roese <sr at denx.de>
Cc: Mario Six <mario.six at gdsys.cc>
Cc: Heiko Schocher <hs at denx.de>
---
 drivers/i2c/mvtwsi.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/i2c/mvtwsi.c b/drivers/i2c/mvtwsi.c
index ab7481a..3765fed 100644
--- a/drivers/i2c/mvtwsi.c
+++ b/drivers/i2c/mvtwsi.c
@@ -595,7 +595,7 @@ static int __twsi_i2c_read(struct mvtwsi_registers *twsi, uchar chip,
 		status = i2c_begin(twsi, expected_start, (chip << 1), tick);
 		/* Send address bytes */
 		while ((status == 0) && alen--)
-			status = twsi_send(twsi, *(addr++),
+			status = twsi_send(twsi, addr[alen],
 					   MVTWSI_STATUS_DATA_W_ACK, tick);
 		/* Send repeated STARTs after the initial START */
 		expected_start = MVTWSI_STATUS_REPEATED_START;
@@ -642,7 +642,7 @@ static int __twsi_i2c_write(struct mvtwsi_registers *twsi, uchar chip,
 	status = i2c_begin(twsi, MVTWSI_STATUS_START, (chip << 1), tick);
 	/* Send address bytes */
 	while ((status == 0) && (alen-- > 0))
-		status = twsi_send(twsi, *(addr++), MVTWSI_STATUS_DATA_W_ACK,
+		status = twsi_send(twsi, addr[alen], MVTWSI_STATUS_DATA_W_ACK,
 				   tick);
 	/* Send data bytes */
 	while ((status == 0) && (length-- > 0))
-- 
2.9.3