[U-Boot] [PATCH 2/3] board: ti: am57xx-evm: fix build warnings

[Lokesh Vutla]

On Thursday 25 August 2016 08:44 PM, Sekhar Nori wrote:
> USB1 is not used on AM57xx GP EVM in device mode.
> Enabling DWC3 USB support for AM57xx EVM gives
> the following warnings:
> 
>   CC      board/ti/am57xx/board.o
> ../board/ti/am57xx/board.c:448:27: warning: 'usb_otg_ss1' defined but not used [-Wunused-variable]
>  static struct dwc3_device usb_otg_ss1 = {
>                            ^
> ../board/ti/am57xx/board.c:455:32: warning: 'usb_otg_ss1_glue' defined but not used [-Wunused-variable]
>  static struct dwc3_omap_device usb_otg_ss1_glue = {
>                                 ^
> ../board/ti/am57xx/board.c:461:33: warning: 'usb_phy1_device' defined but not used [-Wunused-variable]
>  static struct ti_usb_phy_device usb_phy1_device = {
> 
> Fix it by getting rid of USB1 related structures from
> board.c. They can be added back if there is a need for
> them.

Reviewed-by: Lokesh Vutla <lokeshvutla at ti.com>

Thanks and regards,
Lokesh

> 
> Signed-off-by: Sekhar Nori <nsekhar at ti.com>
> ---
>  board/ti/am57xx/board.c | 20 --------------------
>  1 file changed, 20 deletions(-)
> 
> diff --git a/board/ti/am57xx/board.c b/board/ti/am57xx/board.c
> index 927d1364fe46..288ff346e0ca 100644
> --- a/board/ti/am57xx/board.c
> +++ b/board/ti/am57xx/board.c
> @@ -445,26 +445,6 @@ int spl_start_uboot(void)
>  #endif
>  
>  #ifdef CONFIG_USB_DWC3
> -static struct dwc3_device usb_otg_ss1 = {
> -	.maximum_speed = USB_SPEED_SUPER,
> -	.base = DRA7_USB_OTG_SS1_BASE,
> -	.tx_fifo_resize = false,
> -	.index = 0,
> -};
> -
> -static struct dwc3_omap_device usb_otg_ss1_glue = {
> -	.base = (void *)DRA7_USB_OTG_SS1_GLUE_BASE,
> -	.utmi_mode = DWC3_OMAP_UTMI_MODE_SW,
> -	.index = 0,
> -};
> -
> -static struct ti_usb_phy_device usb_phy1_device = {
> -	.pll_ctrl_base = (void *)DRA7_USB3_PHY1_PLL_CTRL,
> -	.usb2_phy_power = (void *)DRA7_USB2_PHY1_POWER,
> -	.usb3_phy_power = (void *)DRA7_USB3_PHY1_POWER,
> -	.index = 0,
> -};
> -
>  static struct dwc3_device usb_otg_ss2 = {
>  	.maximum_speed = USB_SPEED_HIGH,
>  	.base = DRA7_USB_OTG_SS2_BASE,
>