[U-Boot] [PATCH v4 00/16] imx6: Add Engicam GEAM6UL/i.CoreM6 RQS board support

[Jagan Teki]

Hi Stefano,

On Tue, Dec 13, 2016 at 5:56 PM, Jagan Teki <jagan at openedev.com> wrote:
> From: Jagan Teki <jagan at amarulasolutions.com>
>
> This is v4 for previous v3, v2 series[1] [2] on top of [3] series
>
> Changes for v4:
> - Add FEC patches.
>
> Changes for v3:
> - Add I2C support
>
> Changes for v2:
> - Add 'Acked-by' from Joe
> - Add new i.CoreM6 RQS patches
>
> [1] https://www.mail-archive.com/u-boot@lists.denx.de/msg230990.html
> [2] https://www.mail-archive.com/u-boot@lists.denx.de/msg230283.html
> [3] [PATCH v3 00/13] imx6: icorem6: Add dm-eth, framebuffer and I2C support
>
> Jagan Teki (16):
>   arm: dts: Add devicetree for i.MX6UL
>   arm: imx6ul: Add Engicam GEAM6UL Starter Kit initial support
>   arm: dts: imx6ul-geam: Add I2C nodes
>   imx6: geam6ul: Add I2C support
>   imx6: geam6ul: Add NAND support
>   imx6: geam6ul: Enable MTD device support
>   imx6: geam6ul: Add default mtd nand partition table
>   arm: imx6q: Add Engicam i.CoreM6 Quad/Dual RQS Starter Kit initial
>     support
>   arm: imx6q: Add Engicam i.CoreM6 Solo/Duallite RQS Starter Kit initial
>     support
>   imx6: icorem6: Rename engicam icorem6 defconfig files
>   arm: dts: imx6qdl-icore-rqs: Add I2C node's
>   imx6: icorem6_rqs: Add I2C support
>   arm: dts: imx6ul-geam: Add FEC node
>   imx6: geam6ul: Add FEC support
>   arm: dts: imx6qdl-icore-rqs: Add FEC node
>   imx6: icorem6_rqs: Add FEC support

Any help? this is getting delay since so-long.

thanks!
-- 
Jagan Teki
Free Software Engineer | www.openedev.com
U-Boot, Linux | Upstream Maintainer
Hyderabad, India.