[U-Boot] [PATCH 2/2] net: zynq_gem: Use clock driver for ZynqMP
Michal Simek
michal.simek at xilinx.com
Fri Dec 16 13:31:29 CET 2016
From: Siva Durga Prasad Paladugu <siva.durga.paladugu at xilinx.com>
Enable and use the clock driver routine
defined in clock driver toset required
clock appropriately.
Signed-off-by: Siva Durga Prasad Paladugu <sivadur at xilinx.com>
Signed-off-by: Michal Simek <michal.simek at xilinx.com>
---
arch/arm/include/asm/arch-zynqmp/sys_proto.h | 2 ++
drivers/net/zynq_gem.c | 18 ++++++++++++++++++
2 files changed, 20 insertions(+)
diff --git a/arch/arm/include/asm/arch-zynqmp/sys_proto.h b/arch/arm/include/asm/arch-zynqmp/sys_proto.h
index 1db2bd6a4f7a..95fd91da2915 100644
--- a/arch/arm/include/asm/arch-zynqmp/sys_proto.h
+++ b/arch/arm/include/asm/arch-zynqmp/sys_proto.h
@@ -8,10 +8,12 @@
#ifndef _ASM_ARCH_SYS_PROTO_H
#define _ASM_ARCH_SYS_PROTO_H
+#ifndef CONFIG_CLK_ZYNQMP
/* Setup clk for network */
static inline void zynq_slcr_gem_clk_setup(u32 gem_id, unsigned long clk_rate)
{
}
+#endif
int zynq_slcr_get_mio_pin_status(const char *periph);
diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c
index 95b4d6e4f0aa..6dd87cf28f95 100644
--- a/drivers/net/zynq_gem.c
+++ b/drivers/net/zynq_gem.c
@@ -9,6 +9,7 @@
* SPDX-License-Identifier: GPL-2.0+
*/
+#include <clk.h>
#include <common.h>
#include <dm.h>
#include <net.h>
@@ -181,6 +182,9 @@ struct zynq_gem_priv {
struct phy_device *phydev;
int phy_of_handle;
struct mii_dev *bus;
+#ifdef CONFIG_CLK_ZYNQMP
+ struct clk clk;
+#endif
};
static u32 phy_setup_op(struct zynq_gem_priv *priv, u32 phy_addr, u32 regnum,
@@ -455,8 +459,14 @@ static int zynq_gem_init(struct udevice *dev)
/* Change the rclk and clk only not using EMIO interface */
if (!priv->emio)
+#ifndef CONFIG_CLK_ZYNQMP
zynq_slcr_gem_clk_setup((ulong)priv->iobase !=
ZYNQ_GEM_BASEADDR0, clk_rate);
+#else
+ ret = clk_set_rate(&priv->clk, clk_rate);
+ if (IS_ERR_VALUE(ret))
+ return -1;
+#endif
setbits_le32(®s->nwctrl, ZYNQ_GEM_NWCTRL_RXEN_MASK |
ZYNQ_GEM_NWCTRL_TXEN_MASK);
@@ -629,6 +639,14 @@ static int zynq_gem_probe(struct udevice *dev)
priv->tx_bd = (struct emac_bd *)bd_space;
priv->rx_bd = (struct emac_bd *)((ulong)bd_space + BD_SEPRN_SPACE);
+#ifdef CONFIG_CLK_ZYNQMP
+ ret = clk_get_by_name(dev, "tx_clk", &priv->clk);
+ if (ret < 0) {
+ dev_err(dev, "failed to get clock\n");
+ return -EINVAL;
+ }
+#endif
+
priv->bus = mdio_alloc();
priv->bus->read = zynq_gem_miiphy_read;
priv->bus->write = zynq_gem_miiphy_write;
--
1.9.1
More information about the U-Boot
mailing list