[U-Boot] [PATCH 02/11] net: designware: Use dm_pci_mem_to_phys() in the probe routine

[Bin Meng]

Convert to use native DM PCI API dm_pci_mem_to_phys().

Signed-off-by: Bin Meng <bmeng.cn at gmail.com>
---

 drivers/net/designware.c | 4 +---
 1 file changed, 1 insertion(+), 3 deletions(-)

diff --git a/drivers/net/designware.c b/drivers/net/designware.c
index 77b98c9..ca58f34 100644
--- a/drivers/net/designware.c
+++ b/drivers/net/designware.c
@@ -591,11 +591,9 @@ static int designware_eth_probe(struct udevice *dev)
 	 * or via a PCI bridge, fill in platdata before we probe the hardware.
 	 */
 	if (device_is_on_pci_bus(dev)) {
-		pci_dev_t bdf = dm_pci_get_bdf(dev);
-
 		dm_pci_read_config32(dev, PCI_BASE_ADDRESS_0, &iobase);
 		iobase &= PCI_BASE_ADDRESS_MEM_MASK;
-		iobase = pci_mem_to_phys(bdf, iobase);
+		iobase = dm_pci_mem_to_phys(dev, iobase);
 
 		pdata->iobase = iobase;
 		pdata->phy_interface = PHY_INTERFACE_MODE_RMII;
-- 
1.8.2.1