[U-Boot] [PATCH v2] arm: use common instructions applicable to armv7m & other arm archs

[Vikas Manocha]

This patch cleans the code by using instructions allowed for armv7m as well as
other Arm archs.

Signed-off-by: Vikas Manocha <vikas.manocha at st.com>
Reviewed-by: Simon Glass <sjg at chromium.org>
---
Changes in v2: reword message commit. Removed info regarding BIC
instruction on SP, was creating confusion.

 arch/arm/lib/crt0.S | 25 +++++++------------------
 1 file changed, 7 insertions(+), 18 deletions(-)

diff --git a/arch/arm/lib/crt0.S b/arch/arm/lib/crt0.S
index 2f4c14e..3731d0c 100644
--- a/arch/arm/lib/crt0.S
+++ b/arch/arm/lib/crt0.S
@@ -71,18 +71,12 @@ ENTRY(_main)
  */
 
 #if defined(CONFIG_SPL_BUILD) && defined(CONFIG_SPL_STACK)
-	ldr	sp, =(CONFIG_SPL_STACK)
+	ldr	r0, =(CONFIG_SPL_STACK)
 #else
-	ldr	sp, =(CONFIG_SYS_INIT_SP_ADDR)
+	ldr	r0, =(CONFIG_SYS_INIT_SP_ADDR)
 #endif
-#if defined(CONFIG_CPU_V7M)	/* v7M forbids using SP as BIC destination */
-	mov	r3, sp
-	bic	r3, r3, #7
-	mov	sp, r3
-#else
-	bic	sp, sp, #7	/* 8-byte alignment for ABI compliance */
-#endif
-	mov	r0, sp
+	bic	r0, r0, #7	/* 8-byte alignment for ABI compliance */
+	mov	sp, r0
 	bl	board_init_f_alloc_reserve
 	mov	sp, r0
 	/* set up gd here, outside any C code */
@@ -100,14 +94,9 @@ ENTRY(_main)
  * 'here' but relocated.
  */
 
-	ldr	sp, [r9, #GD_START_ADDR_SP]	/* sp = gd->start_addr_sp */
-#if defined(CONFIG_CPU_V7M)	/* v7M forbids using SP as BIC destination */
-	mov	r3, sp
-	bic	r3, r3, #7
-	mov	sp, r3
-#else
-	bic	sp, sp, #7	/* 8-byte alignment for ABI compliance */
-#endif
+	ldr	r0, [r9, #GD_START_ADDR_SP]	/* sp = gd->start_addr_sp */
+	bic	r0, r0, #7
+	mov	sp, r0		/* 8-byte alignment for ABI compliance */
 	ldr	r9, [r9, #GD_BD]		/* r9 = gd->bd */
 	sub	r9, r9, #GD_SIZE		/* new GD is below bd */
 
-- 
1.9.1