[U-Boot] [PATCH v4 0/3] UniPhier SD/eMMC controller driver

[Masahiro Yamada]

2016-02-18 19:52 GMT+09:00 Masahiro Yamada <yamada.masahiro at socionext.com>:
>
>
> Changes in v4:
>   - Add some comments about HOST_MODE register
>   - Rename uniphier_sd_wait_irq() to uniphier_sd_wait_for_irq()
>
> Changes in v3:
>   - Use dev_err/dev_dbg instead of pr_err/pr_debug
>   - Tidy up uniphier_sd_set_ios()
>   - Allow to use DMA even in SPL if the target address is DMA'able
>
> Changes in v2:
>   - Fix the divisor bug on the older IP (on PH1-LD4, PH1-sLD8, PH1-Pro4)
>   - Increase time out because "mmc erase" can sometimes take long
>   - Move HOST_MODE register setting to uniphier_sd_init()
>     because this register does not need setting multipule times.
>
> Masahiro Yamada (3):
>   mmc: uniphier: add driver for UniPhier SD/MMC host controller
>   ARM: uniphier: enable UniPhier SD/MMC host driver
>   ARM: dts: uniphier: add SD/MMC host controller nodes
>

Series, applied to u-boot-uniphier.



-- 
Best Regards
Masahiro Yamada