[U-Boot] [PATCH 05/17] drivers: usb: musb: adopt musb backend driver to driver model

[Marek Vasut]

On 02/29/2016 04:44 AM, Mugunthan V N wrote:
> Currently all backend driver ops uses hard coded physical
> address, so to adopt the driver to DM, add device pointer to ops
> call backs so that drivers that drivers can get physical
> addresses from the usb driver priv/plat data.
> 
> Signed-off-by: Mugunthan V N <mugunthanvnm at ti.com>
> ---

[...]

> @@ -704,8 +719,13 @@ static int dsps_resume(struct device *dev)
>  	struct omap_musb_board_data *data = plat->board_data;
>  
>  	/* Start the on-chip PHY and its PLL. */
> +#ifndef CONFIG_DM_USB
>  	if (data->set_phy_power)
>  		data->set_phy_power(1);
> +#else
> +	if (data->set_phy_power)
> +		data->set_phy_power(data->dev, 1);

Would it be possible to avoid adding this sea of ifdefs into the driver?

> +#endif
>  
>  	return 0;
>  }
> 


-- 
Best regards,
Marek Vasut