[U-Boot] [PATCH 2/9] usb: ehci-mx6: configure power polarity in usb_power_config

[Stefan Agner]

From: Stefan Agner <stefan.agner at toradex.com>

USBNC_n_CTRL1 bit 9 actually controls the power pin polarity.
Rename UCTRL_PM to align reference manual and set the bit in
the appropriate callback usb_power_config.

Signed-off-by: Stefan Agner <stefan.agner at toradex.com>
---

 drivers/usb/host/ehci-mx6.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/usb/host/ehci-mx6.c b/drivers/usb/host/ehci-mx6.c
index bb48d0d..0dbabb2 100644
--- a/drivers/usb/host/ehci-mx6.c
+++ b/drivers/usb/host/ehci-mx6.c
@@ -49,7 +49,7 @@
 #define USBNC_OFFSET		0x200
 #define USBNC_PHYSTATUS_ID_DIG	(1 << 4) /* otg_id status */
 #define USBNC_PHYCFG2_ACAENB	(1 << 4) /* otg_id detection enable */
-#define UCTRL_PM                (1 << 9) /* OTG Power Mask */
+#define UCTRL_PWR_POL		(1 << 9) /* OTG Polarity of Power Pin */
 #define UCTRL_OVER_CUR_POL	(1 << 8) /* OTG Polarity of Overcurrent */
 #define UCTRL_OVER_CUR_DIS	(1 << 7) /* Disable OTG Overcurrent Detection */
 
@@ -206,9 +206,13 @@ static void usb_power_config(int index)
 	struct usbnc_regs *usbnc = (struct usbnc_regs *)(USB_BASE_ADDR +
 			(0x10000 * index) + USBNC_OFFSET);
 	void __iomem *phy_cfg2 = (void __iomem *)(&usbnc->phy_cfg2);
+	void __iomem *ctrl = (void __iomem *)(&usbnc->ctrl1);
 
 	/* Enable usb_otg_id detection */
 	setbits_le32(phy_cfg2, USBNC_PHYCFG2_ACAENB);
+
+	/* Set power polarity to high active */
+	setbits_le32(ctrl, UCTRL_PWR_POL);
 }
 
 int usb_phy_mode(int port)
@@ -246,11 +250,7 @@ static void usb_oc_config(int index)
 	setbits_le32(ctrl, UCTRL_OVER_CUR_POL);
 #endif
 
-#if defined(CONFIG_MX6)
 	setbits_le32(ctrl, UCTRL_OVER_CUR_DIS);
-#elif defined(CONFIG_MX7)
-	setbits_le32(ctrl, UCTRL_OVER_CUR_DIS | UCTRL_PM);
-#endif
 }
 
 /**
-- 
2.9.0