[U-Boot] [PATCH v2 1/3] spi: spi_flash: Dont set quad enable for micron in all cases

Jagan Teki jagannadh.teki at gmail.com
Thu Jul 14 08:07:53 CEST 2016


On 21 June 2016 at 17:22, Siva Durga Prasad Paladugu
<siva.durga.paladugu at xilinx.com> wrote:
> Hi Tom,
>
>> -----Original Message-----
>> From: Siva Durga Prasad Paladugu
>> Sent: Tuesday, June 14, 2016 2:48 PM
>> To: jagannadh.teki at gmail.com; 'Siva Durga Prasad Paladugu'
>> <siva.durga.paladugu at xilinx.com>; u-boot at lists.denx.de
>> Cc: Michal Simek <michals at xilinx.com>
>> Subject: RE: [PATCH v2 1/3] spi: spi_flash: Dont set quad enable for micron in all
>> cases
>>
>> -----Original Message-----
>> From: Siva Durga Prasad Paladugu [mailto:siva.durga.paladugu at xilinx.com]
>> Sent: Thursday, May 26, 2016 12:28 PM
>> To: u-boot at lists.denx.de
>> Cc: Michal Simek <michals at xilinx.com>; jagannadh.teki at gmail.com; Siva Durga
>> Prasad Paladugu <sivadur at xilinx.com>
>> Subject: [PATCH v2 1/3] spi: spi_flash: Dont set quad enable for micron in all
>> cases
>>
>> Dont set quad enable for micron devices in all cases Setting the quad enable bit
>> in micron expects all other commands like register reads on quad lines which
>> may not be supported by some controllers. Hence, dont set the quad enable if
>> controller driver sets the no_all_quad.
>>
>> Hi Jagan,
>>
>> Any comments on this series. If not, Please take this series.
>>
>> Regards,
>> Siva
>
> If Jagan is busy, Is it possible to get it acked/reviewed from some other person and can go through your tree/Michal tree.

These are big changes on common code, please add cover-letter,
describe the text and send again.

thanks!
-- 
Jagan.


More information about the U-Boot mailing list