[U-Boot] u-boot: x86: interrupt mapping

[Jian Luo]

Hallo Christian,

On 19.07.2016 08:02, Christian Gmeiner wrote:
> Hi Bin
>
>>> For the moment I have no answer to this question. I need to dive into
>>> the vxworks code, which
>>> is not what I like to do now (but needs to be done)-
>>>
>> Yes, please do track it down. The interrupt line register configured
>> by U-Boot should be enough for VxWorks to function under PIC mode.
>>
>>> I have an other (wired) question you may could help out.
>>>
>>> http://www.mouser.com/pdfdocs/Intel_Platform_Controller_Hub_EG20T_datasheet.pdf
>>> (page 124)
>>>
>>> On my development board the uart_clk is connected to a oscillator and
>>> everything works as expected.
>>> But on the production devices the uart_clk is not connected and fsp
>>> hangs with post code 0x2e.
>>>
>> I am not sure about the meaning of post code 0x2e. Jian has some
>> working experience on Atom E6xx with U-Boot. Adding him.
>>
> 0x2e == POST_PRE_MRC (arch/x86/include/asm/post.h)
>
>>> Now I would like to change the initial mux settings to use usb_48mhz
>>> but I am quite sure that I need
>>> to have the pci bus and its devices initialised already in order to
>>> change the CLKCFG register. Do you
>>> think there is an other way of accessing this register like fixed
>>> memory address etc?
>>>
>> Which register do you want to program for this uart_clk? If it's on
>> the PCI configuration space, you can use PCI config APIs to program.
>>
> There a handful of registers I would need to program but all of them are
> accessible via pic config space. E.g CLKCFG:
>
> Size: 32-bit Default: 20000C00 Power Well: Core
> Access PCI Configuration B:D:F D0:F0 Offset Start: Offset End: 500h 503h
>              Memory Mapped I/O BAR: PKTHubCTLBASE Offset: 500h
>
>
> As I need to program those registers before fsp_init I must setup the pci
> bus by myself, change the register values and call fsb_init routine. Correct?
My board had this problem too. I however toke a different approach
by patching the original FSP. The waiting for Topcliff UART ready is 
completely
bypassed in all UEFI blobs. You can use UEFITool [1] to extract blobs in
the attached FSP for comparison.
>
> greets
> --
> Christian Gmeiner, MSc
>
> https://soundcloud.com/christian-gmeiner
[1] https://github.com/LongSoft/UEFITool

Best regards,

*Jian Luo
DC-IA/EAH2*

Tel.  +49(9352)18-4266

*Be**QIK
*

-------------- next part --------------
A non-text attachment was scrubbed...
Name: fsp.bin
Type: application/octet-stream
Size: 139264 bytes
Desc: not available
URL: <http://lists.denx.de/pipermail/u-boot/attachments/20160719/508318ef/attachment-0001.bin>