[U-Boot] [PATCH 2/2] config.h: clean unused CONFIG_ENV_SPI_* if using driver model

[Gong Qianyu]

When using SPI driver model, it will get the values from DT. So
there is no need to set CONFIG_ENV_SPI_MAX_HZ and
CONFIG_ENV_SPI_MODE any more.

Signed-off-by: Gong Qianyu <Qianyu.Gong at nxp.com>
---
 include/configs/ls1012a_common.h | 2 --
 include/configs/ls1043a_common.h | 2 --
 2 files changed, 4 deletions(-)

diff --git a/include/configs/ls1012a_common.h b/include/configs/ls1012a_common.h
index fba2fac..1602f09 100644
--- a/include/configs/ls1012a_common.h
+++ b/include/configs/ls1012a_common.h
@@ -52,8 +52,6 @@
 #define CONFIG_SYS_FMAN_FW_ADDR		0x400d0000
 #define CONFIG_ENV_SPI_BUS		0
 #define CONFIG_ENV_SPI_CS		0
-#define CONFIG_ENV_SPI_MAX_HZ		1000000
-#define CONFIG_ENV_SPI_MODE		0x03
 #define CONFIG_SPI_FLASH_SPANSION
 #define CONFIG_FSL_SPI_INTERFACE
 #define CONFIG_SF_DATAFLASH
diff --git a/include/configs/ls1043a_common.h b/include/configs/ls1043a_common.h
index b0d4a8d..028f7d9 100644
--- a/include/configs/ls1043a_common.h
+++ b/include/configs/ls1043a_common.h
@@ -222,8 +222,6 @@
 #define CONFIG_SYS_FMAN_FW_ADDR		0x400d0000
 #define CONFIG_ENV_SPI_BUS		0
 #define CONFIG_ENV_SPI_CS		0
-#define CONFIG_ENV_SPI_MAX_HZ		1000000
-#define CONFIG_ENV_SPI_MODE		0x03
 #else
 #define CONFIG_SYS_QE_FMAN_FW_IN_NOR
 /* FMan fireware Pre-load address */
-- 
2.1.0.27.g96db324