[U-Boot] [RFC PATCH 7/9] mx6memcal: add configuration for Wandboard Quad

[Eric Nelson]

Note that for some reason, this is failing for me unless I
select a DDR bus width of 32 bits.

Signed-off-by: Eric Nelson <eric at nelint.com>
---
 configs/mx6memcal_wandboard_quad_defconfig | 34 ++++++++++++++++++++++++++++++
 1 file changed, 34 insertions(+)
 create mode 100644 configs/mx6memcal_wandboard_quad_defconfig

diff --git a/configs/mx6memcal_wandboard_quad_defconfig b/configs/mx6memcal_wandboard_quad_defconfig
new file mode 100644
index 0000000..291c273
--- /dev/null
+++ b/configs/mx6memcal_wandboard_quad_defconfig
@@ -0,0 +1,34 @@
+CONFIG_ARM=y
+CONFIG_ARCH_MX6=y
+CONFIG_SPL_LIBCOMMON_SUPPORT=y
+CONFIG_SPL_LIBGENERIC_SUPPORT=y
+CONFIG_MX6_DDRCAL=y
+CONFIG_TARGET_MX6MEMCAL=y
+CONFIG_DDRCS=1
+CONFIG_H5TQ4G63AFR=y
+CONFIG_SPL_SERIAL_SUPPORT=y
+CONFIG_SPL_WATCHDOG_SUPPORT=y
+CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=arch/arm/imx-common/spl_sd.cfg,SPL,MX6QDL"
+CONFIG_SPL=y
+CONFIG_HUSH_PARSER=y
+# CONFIG_CMD_BOOTD is not set
+# CONFIG_CMD_BOOTM is not set
+# CONFIG_CMD_ELF is not set
+# CONFIG_CMD_IMI is not set
+# CONFIG_CMD_IMLS is not set
+# CONFIG_CMD_XIMG is not set
+# CONFIG_CMD_EXPORTENV is not set
+# CONFIG_CMD_IMPORTENV is not set
+# CONFIG_CMD_EDITENV is not set
+# CONFIG_CMD_SAVEENV is not set
+# CONFIG_CMD_ENV_EXISTS is not set
+CONFIG_CMD_MEMTEST=y
+CONFIG_CMD_MEMINFO=y
+# CONFIG_CMD_LOADB is not set
+# CONFIG_CMD_LOADS is not set
+# CONFIG_CMD_FLASH is not set
+# CONFIG_CMD_FPGA is not set
+# CONFIG_CMD_NET is not set
+# CONFIG_CMD_NFS is not set
+CONFIG_CMD_CACHE=y
+CONFIG_REGEX=y
-- 
2.7.4