[U-Boot] [PATCHv2 1/3] igep00x0: disable CONFIG_DISPLAY_BOARDINFO

[Javier Martinez Canillas]

Hello Ladis,

On Fri, Nov 4, 2016 at 2:21 PM, Ladislav Michl <ladis at linux-mips.org> wrote:
> On Fri, Nov 04, 2016 at 12:42:57PM -0300, Javier Martinez Canillas wrote:
>> Hello Ladis,
>>
>> On 11/04/2016 08:55 AM, Ladislav Michl wrote:
>> > As a single U-Boot binary can now run on various board modifications,
>> > drop CONFIG_DISPLAY_BOARDINFO as it prints flash memory information
>> > too early to give us chance to easily detect it. Also saves few bytes
>> > as a bonus.
>> >
>> > Signed-off-by: Ladislav Michl <ladis at linux-mips.org>
>> > ---
>>
>> I tried to test your patches on latest u-boot master (sha-1 dd93a8e9e688)
>> but my IGEPv2 board fails to boot and prints in an infinite loop following:
>>
>> "ecc unrecoverable error"
>
> This comes from SPL, right? That would imply you boot from NAND...
>
>> This is not related to your patches though, since I've the same issue
>> without your patches applied.
>>
>> Did you see this issue? u-boot works with previous v2016.09 release so
>> this is a newly introduced regression.
>
> No, otherwise I would fix that. Care to send complete boot log if there is
> any?
>

As talked on irc, this is because I don't have an UBI partition on my
NAND. I've just commented the error messages for now to be able to
boot since this is an unrelated issue.

>> Unfortunately I don't have time to dig deeper on this but I may give a
>> try next week.
>
> Thank you,
>         ladis

Best regards,
Javier