[U-Boot] [PATCH v2 10/22] spi: Add error checking for invalid bus widths

[Simon Glass]

At present an invalid bus width prints a message but does not return an
error. This is the opposite of the correct behaviour. Adjust it to avoid
code bloat in the common case, and avoid hard-to-debug failure in the
uncommon case.

Signed-off-by: Simon Glass <sjg at chromium.org>
---

Changes in v2: None

 drivers/spi/spi-uclass.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/spi/spi-uclass.c b/drivers/spi/spi-uclass.c
index 26eada2..358e229 100644
--- a/drivers/spi/spi-uclass.c
+++ b/drivers/spi/spi-uclass.c
@@ -415,8 +415,8 @@ int spi_slave_ofdata_to_platdata(const void *blob, int node,
 		mode |= SPI_TX_QUAD;
 		break;
 	default:
-		error("spi-tx-bus-width %d not supported\n", value);
-		break;
+		debug("spi-tx-bus-width %d not supported\n", value);
+		return -EPROTONOSUPPORT;
 	}
 
 	value = fdtdec_get_uint(blob, node, "spi-rx-bus-width", 1);
@@ -430,8 +430,8 @@ int spi_slave_ofdata_to_platdata(const void *blob, int node,
 		mode |= SPI_RX_QUAD;
 		break;
 	default:
-		error("spi-rx-bus-width %d not supported\n", value);
-		break;
+		debug("spi-rx-bus-width %d not supported\n", value);
+		return -EPROTONOSUPPORT;
 	}
 
 	plat->mode = mode;
-- 
2.8.0.rc3.226.g39d4020