[U-Boot] [PATCH 1/4] fsl/ddr: Fix compiling warning

[Shengzhou Liu]

Fix following warning in case multiple erratum macro was not defined.
warning: unused variable 'tmp'
warning: unused variable 'ddr_freq'

Signed-off-by: Shengzhou Liu <Shengzhou.Liu at nxp.com>
---
 drivers/ddr/fsl/fsl_ddr_gen4.c | 43 +++++++++++++++++-------------------------
 1 file changed, 17 insertions(+), 26 deletions(-)

diff --git a/drivers/ddr/fsl/fsl_ddr_gen4.c b/drivers/ddr/fsl/fsl_ddr_gen4.c
index 042af09..2e36c75 100644
--- a/drivers/ddr/fsl/fsl_ddr_gen4.c
+++ b/drivers/ddr/fsl/fsl_ddr_gen4.c
@@ -47,13 +47,9 @@ void fsl_ddr_set_memctl_regs(const fsl_ddr_cfg_regs_t *regs,
 {
 	unsigned int i, bus_width;
 	struct ccsr_ddr __iomem *ddr;
-	u32 temp_sdram_cfg;
+	u32 temp32;
 	u32 total_gb_size_per_controller;
 	int timeout;
-#if defined(CONFIG_SYS_FSL_ERRATUM_A008511) || \
-	defined(CONFIG_SYS_FSL_ERRATUM_A009801)
-	u32 temp32;
-#endif
 
 #ifdef CONFIG_SYS_FSL_ERRATUM_A008511
 	u32 mr6;
@@ -61,11 +57,6 @@ void fsl_ddr_set_memctl_regs(const fsl_ddr_cfg_regs_t *regs,
 	u32 vref_seq2[3] = {0xc0, 0xf0, 0x70};	/* for range 2 */
 	u32 *vref_seq = vref_seq1;
 #endif
-#if defined(CONFIG_SYS_FSL_ERRATUM_A009942) | \
-	defined(CONFIG_SYS_FSL_ERRATUM_A010165)
-	ulong ddr_freq;
-	u32 tmp;
-#endif
 #ifdef CONFIG_FSL_DDR_BIST
 	u32 mtcr, err_detect, err_sbe;
 	u32 cs0_bnds, cs1_bnds, cs2_bnds, cs3_bnds, cs0_config;
@@ -291,10 +282,10 @@ void fsl_ddr_set_memctl_regs(const fsl_ddr_cfg_regs_t *regs,
 #endif
 
 #ifdef CONFIG_SYS_FSL_ERRATUM_A010165
-	ddr_freq = get_ddr_freq(ctrl_num) / 1000000;
-	if ((ddr_freq > 1900) && (ddr_freq < 2300)) {
-		tmp = ddr_in32(&ddr->debug[28]);
-		ddr_out32(&ddr->debug[28], tmp | 0x000a0000);
+	temp32 = get_ddr_freq(ctrl_num) / 1000000;
+	if ((temp32 > 1900) && (temp32 < 2300)) {
+		temp32 = ddr_in32(&ddr->debug[28]);
+		ddr_out32(&ddr->debug[28], temp32 | 0x000a0000);
 	}
 #endif
 	/*
@@ -312,9 +303,9 @@ void fsl_ddr_set_memctl_regs(const fsl_ddr_cfg_regs_t *regs,
 
 step2:
 	/* Set, but do not enable the memory */
-	temp_sdram_cfg = regs->ddr_sdram_cfg;
-	temp_sdram_cfg &= ~(SDRAM_CFG_MEM_EN);
-	ddr_out32(&ddr->sdram_cfg, temp_sdram_cfg);
+	temp32 = regs->ddr_sdram_cfg;
+	temp32 &= ~(SDRAM_CFG_MEM_EN);
+	ddr_out32(&ddr->sdram_cfg, temp32);
 
 	/*
 	 * 500 painful micro-seconds must elapse between
@@ -329,18 +320,18 @@ step2:
 #ifdef CONFIG_DEEP_SLEEP
 	if (is_warm_boot()) {
 		/* enter self-refresh */
-		temp_sdram_cfg = ddr_in32(&ddr->sdram_cfg_2);
-		temp_sdram_cfg |= SDRAM_CFG2_FRC_SR;
-		ddr_out32(&ddr->sdram_cfg_2, temp_sdram_cfg);
+		temp32 = ddr_in32(&ddr->sdram_cfg_2);
+		temp32 |= SDRAM_CFG2_FRC_SR;
+		ddr_out32(&ddr->sdram_cfg_2, temp32);
 		/* do board specific memory setup */
 		board_mem_sleep_setup();
 
-		temp_sdram_cfg = (ddr_in32(&ddr->sdram_cfg) | SDRAM_CFG_BI);
+		temp32 = (ddr_in32(&ddr->sdram_cfg) | SDRAM_CFG_BI);
 	} else
 #endif
-		temp_sdram_cfg = ddr_in32(&ddr->sdram_cfg) & ~SDRAM_CFG_BI;
+		temp32 = ddr_in32(&ddr->sdram_cfg) & ~SDRAM_CFG_BI;
 	/* Let the controller go */
-	ddr_out32(&ddr->sdram_cfg, temp_sdram_cfg | SDRAM_CFG_MEM_EN);
+	ddr_out32(&ddr->sdram_cfg, temp32 | SDRAM_CFG_MEM_EN);
 	mb();
 	isb();
 
@@ -483,9 +474,9 @@ step2:
 #ifdef CONFIG_DEEP_SLEEP
 	if (is_warm_boot()) {
 		/* exit self-refresh */
-		temp_sdram_cfg = ddr_in32(&ddr->sdram_cfg_2);
-		temp_sdram_cfg &= ~SDRAM_CFG2_FRC_SR;
-		ddr_out32(&ddr->sdram_cfg_2, temp_sdram_cfg);
+		temp32 = ddr_in32(&ddr->sdram_cfg_2);
+		temp32 &= ~SDRAM_CFG2_FRC_SR;
+		ddr_out32(&ddr->sdram_cfg_2, temp32);
 	}
 #endif
 
-- 
2.1.0.27.g96db324