[U-Boot] [PicoZed] Error in NET and SD Card

[Oscar Gomez Fuente]

Hi Jaehoon,


How can I enable the CONFG_MMC_TRACE? I couldn't find this option in the
menuconfig.

Is it enough to add "CONFIG_MMC_TRACE=y" in the .config file?


Best regards.

Oscar Gomez Fuente.

On 12 October 2016 at 06:46, Jaehoon Chung <jh80.chung at samsung.com> wrote:

> Hi
>
> On 10/11/2016 11:08 PM, Oscar Gomez Fuente wrote:
> > Hi everyone,
> >
> > I've just compiled u-boot for a picoZed platform with
> > the zynq_picozed_defconfig, and I've realised that the NET and SD Card
> > aren't recognised. In the init I see these messages:
> >
> > I boot from the SD Card and I see these messages from my uart terminal:
> >
> > ---------------------
> > U-Boot 2016.11-rc1-00139-gf5fd45f (Oct 11 2016 - 15:48:54 +0200)
> >
> > Model: Zynq PicoZed Board
> > Board: Xilinx Zynq
> > DRAM:  ECC disabled 1 GiB
> > MMC:
> > Using default environment
> >
> > In:    serial at e0001000
> > Out:   serial at e0001000
> > Err:   serial at e0001000
> > Model: Zynq PicoZed Board
> > Board: Xilinx Zynq
> > Net:   No ethernet found.
> > ** Bad device mmc 0 **
> > Checking if uenvcmd is set ...
> > Hit any key to stop autoboot:  0
> > ---------------------
> >
> > So, I think something has broken. Could anyone chek this issue?
>
> Could you enable the CONFIG_MMC_TRACE? then we can see more information.
> And which config do you use?
>
> Best Regards,
> Jaehoon Chung
>
> >
> >
> > Thank you very much. Best regards.
> >
> > Oscar Gomez Fuente
> > _______________________________________________
> > U-Boot mailing list
> > U-Boot at lists.denx.de
> > http://lists.denx.de/mailman/listinfo/u-boot
> >
> >
> >
>
>