[U-Boot] [PATCH v2] arm: imx: add i.MX53 Beckhoff CX9020 Embedded PC

[Patrick Brünn]

>From: Stefano Babic [mailto:sbabic at denx.de]
>Sent: Montag, 17. Oktober 2016 09:32
>
>On 07/10/2016 18:14, linux-kernel-dev at beckhoff.com wrote:
>> From: Patrick Bruenn <p.bruenn at beckhoff.com>
>>
>> Add CX9020 board based on mx53loco.
>> Add simplified imx53 base device tree from kernel v4.8-rc8, to reuse
>> serial_mxc with DTE and prepare for device tree migration of other
>> functions and imx53 devices.
>>
>> The CX9020 differs from i.MX53 Quick Start Board by:
>> - use uart2 instead of uart1
>> - DVI-D connector instead of VGA
>> - no audio
>> - CCAT FPGA connected to emi
>> - enable rtc
>>
>> Signed-off-by: Patrick Bruenn <p.bruenn at beckhoff.com>
>>
>> ---
>
>> +
>> +#ifndef __CONFIG_H
>> +#define __CONFIG_H
>> +
>> +#define CONFIG_MX53
>> +
>> +#define CONFIG_DISPLAY_BOARDINFO
>> +
>
>This results to be defined twice (default is enabled, resulting in a
>warning by building the board. If you agree, I fix it myself before
>applying.
>
Sure I am fine with that.
Thanks and regards,
Patrick

Signed-off-by: Patrick Bruenn <p.bruenn at beckhoff.com>
Beckhoff Automation GmbH & Co. KG | Managing Director: Dipl. Phys. Hans Beckhoff
Registered office: Verl, Germany | Register court: Guetersloh HRA 7075