[U-Boot] [PATCH v1 5/7] board: sama5d3_xplained: clean up code

[Wenyou Yang]

Since the introduction of the pinctrl and clk driver and
the dts file, remove unneeded hard coded related code from
the board file.

Signed-off-by: Wenyou Yang <wenyou.yang at atmel.com>
---

 board/atmel/sama5d3_xplained/sama5d3_xplained.c | 19 -------------------
 1 file changed, 19 deletions(-)

diff --git a/board/atmel/sama5d3_xplained/sama5d3_xplained.c b/board/atmel/sama5d3_xplained/sama5d3_xplained.c
index 2b9da91..c4d67a7 100644
--- a/board/atmel/sama5d3_xplained/sama5d3_xplained.c
+++ b/board/atmel/sama5d3_xplained/sama5d3_xplained.c
@@ -6,14 +6,12 @@
  */
 
 #include <common.h>
-#include <mmc.h>
 #include <asm/io.h>
 #include <asm/arch/sama5d3_smc.h>
 #include <asm/arch/at91_common.h>
 #include <asm/arch/at91_rstc.h>
 #include <asm/arch/gpio.h>
 #include <asm/arch/clk.h>
-#include <atmel_mci.h>
 #include <net.h>
 #include <netdev.h>
 #include <spl.h>
@@ -65,20 +63,12 @@ static void sama5d3_xplained_usb_hw_init(void)
 #ifdef CONFIG_GENERIC_ATMEL_MCI
 static void sama5d3_xplained_mci0_hw_init(void)
 {
-	at91_mci_hw_init();
-
 	at91_set_pio_output(AT91_PIO_PORTE, 2, 0);	/* MCI0 Power */
 }
 #endif
 
 int board_early_init_f(void)
 {
-	at91_periph_clk_enable(ATMEL_ID_PIOA);
-	at91_periph_clk_enable(ATMEL_ID_PIOB);
-	at91_periph_clk_enable(ATMEL_ID_PIOC);
-	at91_periph_clk_enable(ATMEL_ID_PIOD);
-	at91_periph_clk_enable(ATMEL_ID_PIOE);
-
 	at91_seriald_hw_init();
 
 	return 0;
@@ -122,15 +112,6 @@ int board_eth_init(bd_t *bis)
 	return 0;
 }
 
-#ifdef CONFIG_GENERIC_ATMEL_MCI
-int board_mmc_init(bd_t *bis)
-{
-	atmel_mci_init((void *)ATMEL_BASE_MCI0);
-
-	return 0;
-}
-#endif
-
 /* SPL */
 #ifdef CONFIG_SPL_BUILD
 void spl_board_init(void)
-- 
2.7.4