[U-Boot] [PATCH 39/82] x86: Kconfig: Add location options for 16/32-bit init

[Simon Glass]

At present all 16/32-bit init is controlled by CONFIG_X86_RESET_VECTOR. If
this is enabled, then U-Boot is the 'first' boot loader and handles execution
from the reset vector through to U-Boot's command prompt. If it is not
enabled then U-Boot starts at the 32-bit entry and skips most of its init,
assuming that the previous boot loader has done this already.

With the move to suport 64-bit operation, we have more cases to consider.
The 16-bit and 32-bit init may be in SPL rather than in U-Boot proper.

Add Kconfig options which control the location of the 16-bit and the 32-bit
init. These are not intended to be user-setting except for experimentation.
Their values should be determined by whether 64-bit U-Boot is used.

Signed-off-by: Simon Glass <sjg at chromium.org>
---

 arch/x86/Kconfig | 39 +++++++++++++++++++++++++++++++++++++++
 1 file changed, 39 insertions(+)

diff --git a/arch/x86/Kconfig b/arch/x86/Kconfig
index 0505f97..24d8f4f 100644
--- a/arch/x86/Kconfig
+++ b/arch/x86/Kconfig
@@ -135,6 +135,45 @@ config X86_RESET_VECTOR
 	bool
 	default n
 
+# The following options control where the 16-bit and 32-bit init lies
+# If SPL is enabled then it normally holds this init code, and U-Boot proper
+# is normally a 64-bit build.
+#
+# The 16-bit init refers to the reset vector and the small amount of code to
+# get the processor into 32-bit mode. It may be in SPL or in U-Boot proper,
+# or missing altogether if U-Boot is started from EFI or coreboot.
+#
+# The 32-bit init refers to processor init, running binary blobs including
+# FSP, setting up interrupts and anything else that needs to be done in
+# 32-bit code. It is normally in the same place as 32-bit init.
+config X86_16BIT_INIT
+	bool
+	depends on X86_RESET_VECTOR
+	default y if X86_RESET_VECTOR && !SPL
+	help
+	  This is enabled when 16-bit init is in U-Boot proper
+
+config SPL_X86_16BIT_INIT
+	bool
+	depends on X86_RESET_VECTOR
+	default y if X86_RESET_VECTOR && SPL
+	help
+	  This is enabled when 16-bit init is in SPL
+
+config X86_32BIT_INIT
+	bool
+	depends on X86_RESET_VECTOR
+	default y if X86_RESET_VECTOR && !SPL
+	help
+	  This is enabled when 32-bit init is in U-Boot proper
+
+config SPL_X86_32BIT_INIT
+	bool
+	depends on X86_RESET_VECTOR
+	default y if X86_RESET_VECTOR && SPL
+	help
+	  This is enabled when 32-bit init is in SPL
+
 config RESET_SEG_START
 	hex
 	depends on X86_RESET_VECTOR
-- 
2.8.0.rc3.226.g39d4020