[U-Boot] [PATCH] net: phy: realtek: fix enabling of the TX-delay for RTL8211F
Madalin Bucur
madalin.bucur at nxp.com
Fri Aug 18 08:35:24 UTC 2017
The old logic always enabled the TX-delay when the phy-mode was set to
PHY_INTERFACE_MODE_RGMII. With this patch we enable the TX delay for
PHY_INTERFACE_MODE_RGMII_ID and PHY_INTERFACE_MODE_RGMII_TXID and
disable it for PHY_INTERFACE_MODE_RGMII.
Based on a similar change made in the Linux Realtek PHY driver
by Martin Blumenstingl <martin.blumenstingl at googlemail.com>.
Signed-off-by: Madalin Bucur <madalin.bucur at nxp.com>
---
drivers/net/phy/realtek.c | 24 ++++++++++++++----------
1 file changed, 14 insertions(+), 10 deletions(-)
diff --git a/drivers/net/phy/realtek.c b/drivers/net/phy/realtek.c
index 635acf5..6d917f8 100644
--- a/drivers/net/phy/realtek.c
+++ b/drivers/net/phy/realtek.c
@@ -95,17 +95,21 @@ static int rtl8211f_config(struct phy_device *phydev)
phy_write(phydev, MDIO_DEVAD_NONE, MII_BMCR, BMCR_RESET);
- if (phydev->interface == PHY_INTERFACE_MODE_RGMII) {
- /* enable TXDLY */
- phy_write(phydev, MDIO_DEVAD_NONE,
- MIIM_RTL8211F_PAGE_SELECT, 0xd08);
- reg = phy_read(phydev, MDIO_DEVAD_NONE, 0x11);
+ phy_write(phydev, MDIO_DEVAD_NONE,
+ MIIM_RTL8211F_PAGE_SELECT, 0xd08);
+ reg = phy_read(phydev, MDIO_DEVAD_NONE, 0x11);
+
+ /* enable TX-delay for rgmii-id and rgmii-txid, otherwise disable it */
+ if (phydev->interface == PHY_INTERFACE_MODE_RGMII_ID ||
+ phydev->interface == PHY_INTERFACE_MODE_RGMII_TXID)
reg |= MIIM_RTL8211F_TX_DELAY;
- phy_write(phydev, MDIO_DEVAD_NONE, 0x11, reg);
- /* restore to default page 0 */
- phy_write(phydev, MDIO_DEVAD_NONE,
- MIIM_RTL8211F_PAGE_SELECT, 0x0);
- }
+ else
+ reg &= ~MIIM_RTL8211F_TX_DELAY;
+
+ phy_write(phydev, MDIO_DEVAD_NONE, 0x11, reg);
+ /* restore to default page 0 */
+ phy_write(phydev, MDIO_DEVAD_NONE,
+ MIIM_RTL8211F_PAGE_SELECT, 0x0);
/* Set green LED for Link, yellow LED for Active */
phy_write(phydev, MDIO_DEVAD_NONE,
--
2.1.0
More information about the U-Boot
mailing list