[U-Boot] [PATCH v4 0/4] net: phy: Add Broadcom BCM53xx switch driver

[Florian Fainelli]

On 12/09/2017 03:02 PM, Joe Hershberger wrote:
> On Sat, Dec 9, 2017 at 4:59 PM, Florian Fainelli <f.fainelli at gmail.com> wrote:
>> Hi all,
>>
>> This patch series adds support for the Broadcom BCM53xx switches, in particular
>> BCM53125 which is found no the Lamobo R1 board.
>>
>> The driver is largely based on the DSA/b53 driver Linux driver and only
>> incorporates what is necessary to succesfully bring-up all ports (including the
>> management port) for boot over the network:
>>
>> => dhcp
>> dw_adjust_link: Speed: 1000, full duplex
>> BOOTP broadcast 1
>> DHCP client bound to address 192.168.0.11 (3 ms)
>> Using ethernet at 01c50000 device
>> TFTP from server 192.168.0.1; our IP address is 192.168.0.11
>> Filename 'sun7i-a20-lamobo-r1-kernel.bin'.
>> Load address: 0x42000000
>> Loading: #################################################################
>>          #################################################################
>>          ################################
>>          11.6 MiB/s
>> done
>> Bytes transferred = 2371552 (242fe0 hex)
>> =>
>>
>> Joe there is one warning left which does not look legit to me since we now have
>> a help paragraph describing the config symbol:
>>
>> WARNING: please write a paragraph that describes the config symbol fully
>> #34: FILE: drivers/net/phy/Kconfig:15:
>> +config B53_SWITCH
>>
>> and one CHECK left which I intentionally did not fix because it makes the
>> definitions of the bits less clear:
>> CHECK: Prefer using the BIT macro
>> #134: FILE: drivers/net/phy/b53.c:63:
>> +#define   PORT_OVERRIDE_SPEED_100M     (1 << PORT_OVERRIDE_SPEED_S)
> 
> Works for me.o

Should I expect you to queue up these patches in a git tree/branch, or
is someone else picking up networking/PHY patches?
-- 
Florian