[U-Boot] [PATCH v3 3/4] mmc: zynq: Determine base clock frequency via clock framework

[Michal Simek]

On 10.1.2017 10:16, Stefan.Herbrechtsmeier at weidmueller.com wrote:
> Hi Michael
> 
>> -----Ursprüngliche Nachricht-----
>> Von: Michal Simek [mailto:michal.simek at xilinx.com]
>> Gesendet: Dienstag, 6. Dezember 2016 13:59
>> An: Jaehoon Chung; Herbrechtsmeier, Stefan; u-boot at lists.denx.de
>> Cc: Michal Simek; Simon Glass; Albert Aribaud; Michal Simek; Stephen
>> Warren
>> Betreff: Re: [PATCH v3 3/4] mmc: zynq: Determine base clock frequency
>> via clock framework
>>
>> On 5.12.2016 23:22, Jaehoon Chung wrote:
>>> On 12/02/2016 10:24 PM, stefan.herbrechtsmeier at weidmueller.de wrote:
>>>> From: Stefan Herbrechtsmeier <stefan.herbrechtsmeier at weidmueller.de>
>>>>
>>>> The zynq_sdhci controller driver use CONFIG_ZYNQ_SDHCI_MAX_FREQ as
>>>> base clock frequency but this clock is not fixed and depends on the
>>>> hardware configuration. Additionally the value of
>>>> CONFIG_ZYNQ_SDHCI_MAX_FREQ doesn't match the real base clock
>>>> frequency of SDIO_FREQ. Use the clock framework to determine the
>> frequency at run time.
>>>>
>>>> Signed-off-by: Stefan Herbrechtsmeier
>>>> <stefan.herbrechtsmeier at weidmueller.de>
>>>
>>>
>>> Even if this patch is delegated to Michal, i picked to this.
>>> Applied on u-boot-mmc.
>>>
>>
>> Based on my reply in v2 this is not ideal patch
>> http://lists.denx.de/pipermail/u-boot/2016-November/274310.html
>>
>> Not a problem to take these patches should mmc tree but please wait
>> till you have Ack from me.
>>
> Will you ack the patch if I remove the zynq specific code and remove the CONFIG_CLK check with my patch series to move zynq clk driver to DM?

Just going to look at our clk changes for zynq and it can be the part of
this series.
Do you have branch somewhere with pending stuff?

Thanks,
Michal