[U-Boot] [PATCH] SPL: Add spl_early_board_init() generic function

[Lukasz Majewski]

Some boards do require early adjustments (due to e.g. HW fix) in SPL code.
In this particular case such operations must be performed just before ANY
external IC is accessed (good example here is the I2C early bus access).

Signed-off-by: Lukasz Majewski <lukma at denx.de>
---
 common/spl/Kconfig | 8 ++++++++
 common/spl/spl.c   | 6 ++++++
 include/spl.h      | 4 ++++
 3 files changed, 18 insertions(+)

diff --git a/common/spl/Kconfig b/common/spl/Kconfig
index bb99f1f..7e6f9c4 100644
--- a/common/spl/Kconfig
+++ b/common/spl/Kconfig
@@ -185,6 +185,14 @@ config SPL_SAVEENV
 	  "reboot_image" and act accordingly and change the reboot_image
 	  to default mode using setenv and save the environemnt.
 
+config SPL_EARLY_BOARD_INIT
+	bool "Support early board init code"
+	depends on SPL
+	help
+	  Enable support for very early SPL board code adjustments.
+	  Some boards require having adjustements done before any
+	  peripherals being operational (e.g. I2C, SPI, UART).
+
 config SPL_ETH_SUPPORT
 	bool "Support Ethernet"
 	depends on SPL_ENV_SUPPORT
diff --git a/common/spl/spl.c b/common/spl/spl.c
index bdb165a..a15647b 100644
--- a/common/spl/spl.c
+++ b/common/spl/spl.c
@@ -393,6 +393,12 @@ void board_init_r(gd_t *dummy1, ulong dummy2)
 	struct spl_image_info spl_image;
 	int i;
 
+#ifdef CONFIG_SPL_EARLY_BOARD_INIT
+	debug(">>spl:early_board_init()\n");
+
+	spl_early_board_init();
+#endif
+
 	debug(">>spl:board_init_r()\n");
 
 #if defined(CONFIG_SYS_SPL_MALLOC_START)
diff --git a/include/spl.h b/include/spl.h
index e080a82..00a2058 100644
--- a/include/spl.h
+++ b/include/spl.h
@@ -215,6 +215,10 @@ int spl_init(void);
 void spl_board_init(void);
 #endif
 
+#ifdef CONFIG_SPL_EARLY_BOARD_INIT
+void spl_early_board_init(void);
+#endif
+
 /**
  * spl_was_boot_source() - check if U-Boot booted from SPL
  *
-- 
2.1.4