[U-Boot] [PATCH 1/2] regulator: palmas: Add support for LDO1 regulator to provide 1.8V

[Jean-Jacques Hiblot]

From: Kishon Vijay Abraham I <kishon at ti.com>

Modify palmas_mmc1_poweron_ldo() API to set the voltage based on the
voltage parameter passed as argument instead of always setting it to
3.0V. This allows MMC1 to set the LDO1 regulator voltage to 3.3V or 1.8V.
1.8V is required to add support for UHS mode.

Signed-off-by: Kishon Vijay Abraham I <kishon at ti.com>
Signed-off-by: Jean-Jacques Hiblot <jjhiblot at ti.com>
---
 drivers/power/palmas.c | 5 ++---
 1 file changed, 2 insertions(+), 3 deletions(-)

diff --git a/drivers/power/palmas.c b/drivers/power/palmas.c
index c813b21..4e98959 100644
--- a/drivers/power/palmas.c
+++ b/drivers/power/palmas.c
@@ -50,10 +50,9 @@ int palmas_mmc1_poweron_ldo(uint voltage)
 	int ret;
 	/*
 	 * Currently valid for the dra7xx_evm board:
-	 * Set TPS659038 LDO1 to 3.0 V
+	 * Set TPS659038 LDO1 to 3.0 V or 1.8V
 	 */
-	val = LDO_VOLT_3V0;
-	ret = palmas_i2c_write_u8(TPS65903X_CHIP_P1, LDO1_VOLTAGE, val);
+	ret = palmas_i2c_write_u8(TPS65903X_CHIP_P1, LDO1_VOLTAGE, voltage);
 	if (ret) {
 		printf("tps65903x: could not set LDO1 voltage.\n");
 		return ret;
-- 
1.9.1