[U-Boot] [PATCH v4 17/18] x86: minnowmax: Add a environment variable for USB power-on delay

[Bin Meng]

Occasionally it was observed that on Intel MinnowMax board, with a
USB 2.0 device connected to the bottom port, when doing 'usb start'
on the xHCI controller:

  scanning bus 0 for devices... cannot reset port 3!?

But neither of the two USB ports is routed to xHCI root port 3.
Adding some debug information shows that xHCI port 3 PORTSC register
mysteriously reports both CCS = 1 and CSC = 1.

This is not seen every time. After increasing the timeout to wait
for power to become stable, the issue is gone. So this indicates
current default USB power-on delay (20ms) might be at a critical
region where power is stable/unstable. U-Boot provides a mechanism
to have a environment variable to override the default one. Add
one for MinnowMax.

Signed-off-by: Bin Meng <bmeng.cn at gmail.com>
Reviewed-by: Simon Glass <sjg at chromium.org>
Reviewed-by: Stefan Roese <sr at denx.de>
Tested-by: Stefan Roese <sr at denx.de>
---

Changes in v4: None
Changes in v3: None
Changes in v2: None

 include/configs/minnowmax.h | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/include/configs/minnowmax.h b/include/configs/minnowmax.h
index ae95485..6ea607d 100644
--- a/include/configs/minnowmax.h
+++ b/include/configs/minnowmax.h
@@ -20,7 +20,8 @@
 
 #define CONFIG_STD_DEVICES_SETTINGS	"stdin=usbkbd,serial\0" \
 					"stdout=vidconsole,serial\0" \
-					"stderr=vidconsole,serial\0"
+					"stderr=vidconsole,serial\0" \
+					"usb_pgood_delay=40\0"
 
 #define CONFIG_SCSI_DEV_LIST		\
 	{PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_VALLEYVIEW_SATA}, \
-- 
2.9.2