[U-Boot] [PATCH 00/39] dm: sata: Complete driver-model support for SATA

[Simon Glass]

(pruning the cc list a bit)

Hi Jaehoon,

On 4 July 2017 at 13:48, Simon Glass <sjg at chromium.org> wrote:
> This series completes the conversion of SATA to driver model.
>
> Previous work converted SCSI including the SCSI-based SATA driver. This
> series converts the AHCI uclass itself, adding operations and adjusting
> the 'sata' command to work correctly.
>
> An existing board (Compulab Utilite) is used for this work. It uses SATA
> without the SCSI layer. Unfortunately this board does not currently use
> driver model for MMC or USB, nor does it include a device tree. Therefore
> additional patches are included in this series to convert this over. Note
> that USB is rendered inoperative since the relevant device-tree nodes are
> disabled. Further work is needed here (e.g. by the board maintainer) but
> it is well beyond the objective of this series.
>
> A long-standing niggle with MMC has been the CONFIG_DM_MMC_OPS option.
> This was introduced to allow driver model to handle MMC operations rather
> than having them in struct mmc. This was needed since the original uclass
> did not have support for operations.
>
> At present i.MX is the only SoC that defines CONFIG_DM_MMC without
> CONFIG_DM_MMC_OPS. With this driver converted, the option is no longer
> necessary so this series takes the opportunity to drop that option.

Are you planning to review / apply this series please? It is assigned
to you in patchwork. I'd like to resolve this because I have two other
series depending on it

Regards,
Simon