[U-Boot] [PATCH v2] sun50i: h5: Add initial Orangepi Prime support

[Jagan Teki]

On Fri, Jun 2, 2017 at 6:53 PM, Maxime Ripard
<maxime.ripard at free-electrons.com> wrote:
> On Thu, Jun 01, 2017 at 03:25:32PM +0000, Jagan Teki wrote:
>> From: Jagan Teki <jagan at amarulasolutions.com>
>>
>> Orangepi Prime is an open-source single-board computer
>> using the Allwinner h5 SOC.
>>
>> H5 Orangepi Prime has
>> - Quad-core Cortex-A53
>> - 2GB DDR3
>> - Debug TTL UART
>> - 1000M/100M Ethernet RJ45
>> - Three USB 2.0
>> - HDMI
>> - Audio and MIC
>> - Wifi + BT
>> - IR receiver
>> - HDMI
>> - Wifi + BT
>>
>> Boot from MMC:
>> -------------
>> U-Boot SPL 2017.05-00662-ga3f4c05-dirty (May 25 2017 - 13:30:14)
>> DRAM: 2048 MiB
>> Trying to boot from MMC1
>> NOTICE:  BL3-1: Running on H5 (1718) in SRAM A2 (@0x44000)
>> NOTICE:  Configuring SPC Controller
>> NOTICE:  BL3-1: v1.0(debug):aa75c8d
>> NOTICE:  BL3-1: Built : 18:28:27, May 24 2017
>> INFO:    BL3-1: Initializing runtime services
>> INFO:    BL3-1: Preparing for EL3 exit to normal world
>> INFO:    BL3-1: Next image address: 0x4a000000, SPSR: 0x3c9
>>
>> U-Boot 2017.05-00662-ga3f4c05-dirty (May 25 2017 - 13:30:14 +0000) Allwinner Technology
>>
>> CPU:   Allwinner H5 (SUN50I)
>> Model: OrangePi Prime
>> DRAM:  2 GiB
>> MMC:   SUNXI SD/MMC: 0
>> *** Warning - bad CRC, using default environment
>>
>> In:    serial
>> Out:   serial
>> Err:   serial
>> Net:   phy interface7
>> eth0: ethernet at 1c30000
>> starting USB...
>> USB0:   USB EHCI 1.00
>> USB1:   USB OHCI 1.0
>> scanning bus 0 for devices... 1 USB Device(s) found
>>        scanning usb for storage devices... 0 Storage Device(s) found
>> Hit any key to stop autoboot:  0
>>
>> Signed-off-by: Jagan Teki <jagan at amarulasolutions.com>
>
> Acked-by: Maxime Ripard <maxime.ripard at free-electrons.com>

Applied to u-boot-sunxi/master

thanks!
-- 
Jagan Teki
Free Software Engineer | www.openedev.com
U-Boot, Linux | Upstream Maintainer
Hyderabad, India.