[U-Boot] [PATCH] spi: fsl_qspi: Copy 16 byte aligned data in TX FIFO

[Suresh Gupta]

In some of the QSPI controller version, there must be atleast
128bit data available in TX FIFO for any pop operation otherwise
error bit will be set. The code will not make any behavior change
for previous controller as the transfer data size in ipcr register
is still the same.

Patch is tested on LS1046A which do not require 16 bytes aligned and
LS1088A which require 16 bytes aligned data in TX FIFO

Signed-off-by: Suresh Gupta <suresh.gupta at nxp.com>
Signed-off-by: Anupam Kumar <anupam.kumar_1 at nxp.com>
---
 drivers/spi/fsl_qspi.c | 18 ++++++++----------
 1 file changed, 8 insertions(+), 10 deletions(-)

diff --git a/drivers/spi/fsl_qspi.c b/drivers/spi/fsl_qspi.c
index e61c67b..d596377 100644
--- a/drivers/spi/fsl_qspi.c
+++ b/drivers/spi/fsl_qspi.c
@@ -659,22 +659,20 @@ static void qspi_op_write(struct fsl_qspi_priv *priv, u8 *txbuf, u32 len)
 	tx_size = (len > TX_BUFFER_SIZE) ?
 		TX_BUFFER_SIZE : len;
 
-	size = tx_size / 4;
-	for (i = 0; i < size; i++) {
+	size = tx_size / 16;
+	/*
+	 * There must be atleast 128bit data
+	 * available in TX FIFO for any pop operation
+	 */
+	if (tx_size % 16)
+		size++;
+	for (i = 0; i < size * 4; i++) {
 		memcpy(&data, txbuf, 4);
 		data = qspi_endian_xchg(data);
 		qspi_write32(priv->flags, &regs->tbdr, data);
 		txbuf += 4;
 	}
 
-	size = tx_size % 4;
-	if (size) {
-		data = 0;
-		memcpy(&data, txbuf, size);
-		data = qspi_endian_xchg(data);
-		qspi_write32(priv->flags, &regs->tbdr, data);
-	}
-
 	qspi_write32(priv->flags, &regs->ipcr,
 		     (seqid << QSPI_IPCR_SEQID_SHIFT) | tx_size);
 	while (qspi_read32(priv->flags, &regs->sr) & QSPI_SR_BUSY_MASK)
-- 
1.9.3