[U-Boot] [PATCH] igep0020: Enable DISTRO_DEFAULTS on IGEPv2 platforms

[Enric Balletbo i Serra]

Like commit 3337e3af5d3d this enables suitable commands needed for booting
general purpose Linux distribution. This is required for example if we want
to use PXE or DHCP as default boot targets, symbols no longer enabled by
config_distro_defaults.h.

Signed-off-by: Enric Balletbo i Serra <enric.balletbo at collabora.com>
---
 configs/igep0020_defconfig | 10 +---------
 1 file changed, 1 insertion(+), 9 deletions(-)

diff --git a/configs/igep0020_defconfig b/configs/igep0020_defconfig
index 6e0a5e9..e328331 100644
--- a/configs/igep0020_defconfig
+++ b/configs/igep0020_defconfig
@@ -2,6 +2,7 @@ CONFIG_ARM=y
 CONFIG_ARCH_OMAP2PLUS=y
 CONFIG_OMAP34XX=y
 CONFIG_TARGET_OMAP3_IGEP00X0=y
+CONFIG_DISTRO_DEFAULTS=y
 CONFIG_OF_BOARD_SETUP=y
 CONFIG_SYS_EXTRA_OPTIONS="MACH_TYPE=MACH_TYPE_IGEP0020"
 CONFIG_BOOTDELAY=3
@@ -14,8 +15,6 @@ CONFIG_SPL=y
 CONFIG_SPL_MTD_SUPPORT=y
 CONFIG_SPL_ONENAND_SUPPORT=y
 CONFIG_SPL_OS_BOOT=y
-CONFIG_HUSH_PARSER=y
-CONFIG_CMD_BOOTZ=y
 # CONFIG_CMD_IMLS is not set
 CONFIG_CMD_ASKENV=y
 # CONFIG_CMD_FLASH is not set
@@ -25,15 +24,8 @@ CONFIG_CMD_SPI=y
 CONFIG_CMD_I2C=y
 CONFIG_CMD_GPIO=y
 # CONFIG_CMD_SETEXPR is not set
-CONFIG_CMD_DHCP=y
-CONFIG_CMD_MII=y
-CONFIG_CMD_PING=y
 CONFIG_CMD_CACHE=y
-CONFIG_CMD_EXT2=y
-CONFIG_CMD_EXT4=y
 CONFIG_CMD_EXT4_WRITE=y
-CONFIG_CMD_FAT=y
-CONFIG_CMD_FS_GENERIC=y
 CONFIG_CMD_UBI=y
 CONFIG_ISO_PARTITION=y
 CONFIG_EFI_PARTITION=y
-- 
2.9.3