[U-Boot] [PATCH 2/2] rockchip: defconfig: puma-rk3399: update defconfig with video-support

[Philipp Tomsich]

With HDMI output for the RK3399 working, this update the RK3399-Q7
(Puma) defconfig for the new functionality:
1. enables PMIC command (to check if the HDMI voltages are correct)
      +CONFIG_CMD_PMIC=y
      +CONFIG_CMD_REGULATOR=y
2. enables video-output (via HDMI)
      +CONFIG_DM_VIDEO=y
      +CONFIG_DISPLAY=y
      +CONFIG_VIDEO_ROCKCHIP=y
      +CONFIG_DISPLAY_ROCKCHIP_HDMI=y
3. turns on the 'dcache'-command (for a dcache flush) for our QA to
   fill the framebuffer using 'mw.l'
      +CONFIG_CMD_CACHE=y
4. turns on the 'bmp'-command
      +CONFIG_CMD_BMP=y

Signed-off-by: Philipp Tomsich <philipp.tomsich at theobroma-systems.com>
Reviewed-by: Simon Glass <sjg at chromium.org>

---

Changes in v3: None
Changes in v2:
- enable CMD_BMP in the puma-rk3399_defconfig (following a rebase to
  the upstream master after CMD_BMP was migrate to Kconfig)

 configs/puma-rk3399_defconfig | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/configs/puma-rk3399_defconfig b/configs/puma-rk3399_defconfig
index 577aa02..52fec39 100644
--- a/configs/puma-rk3399_defconfig
+++ b/configs/puma-rk3399_defconfig
@@ -26,7 +26,11 @@ CONFIG_CMD_SPI=y
 CONFIG_CMD_I2C=y
 CONFIG_CMD_USB=y
 # CONFIG_CMD_SETEXPR is not set
+CONFIG_CMD_BMP=y
+CONFIG_CMD_CACHE=y
 CONFIG_CMD_TIME=y
+CONFIG_CMD_PMIC=y
+CONFIG_CMD_REGULATOR=y
 CONFIG_SPL_OF_CONTROL=y
 CONFIG_OF_SPL_REMOVE_PROPS="pinctrl-0 pinctrl-names interrupt-parent assigned-clocks assigned-clock-rates assigned-clock-parents"
 CONFIG_REGMAP=y
@@ -74,4 +78,8 @@ CONFIG_USB_XHCI_DWC3=y
 CONFIG_USB_EHCI_HCD=y
 CONFIG_USB_EHCI_GENERIC=y
 CONFIG_USB_STORAGE=y
+CONFIG_DM_VIDEO=y
+CONFIG_DISPLAY=y
+CONFIG_VIDEO_ROCKCHIP=y
+CONFIG_DISPLAY_ROCKCHIP_HDMI=y
 CONFIG_ERRNO_STR=y
-- 
1.9.1