[U-Boot] [PATCH 06/17] mx6ul_14x14_evk: Fix unused variable warning

[Peng Fan]

On Mon, May 08, 2017 at 10:14:24PM -0400, Tom Rini wrote:
>The variable usdhc1_pads is only referenced during SPL builds, add a guard.
>
>Cc: Stefano Babic <sbabic at denx.de>
>Cc: Peng Fan <peng.fan at nxp.com>
>Signed-off-by: Tom Rini <trini at konsulko.com>

Reviewed-by: Peng Fan <peng.fan at nxp.com>

>---
> board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c | 2 ++
> 1 file changed, 2 insertions(+)
>
>diff --git a/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c b/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
>index b28ce1049589..a5746fe08688 100644
>--- a/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
>+++ b/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
>@@ -225,6 +225,7 @@ static iomux_v3_cfg_t const uart1_pads[] = {
> 	MX6_PAD_UART1_RX_DATA__UART1_DCE_RX | MUX_PAD_CTRL(UART_PAD_CTRL),
> };
> 
>+#ifndef CONFIG_SPL_BUILD
> static iomux_v3_cfg_t const usdhc1_pads[] = {
> 	MX6_PAD_SD1_CLK__USDHC1_CLK | MUX_PAD_CTRL(USDHC_PAD_CTRL),
> 	MX6_PAD_SD1_CMD__USDHC1_CMD | MUX_PAD_CTRL(USDHC_PAD_CTRL),
>@@ -240,6 +241,7 @@ static iomux_v3_cfg_t const usdhc1_pads[] = {
> 	/* RST_B */
> 	MX6_PAD_GPIO1_IO09__GPIO1_IO09 | MUX_PAD_CTRL(NO_PAD_CTRL),
> };
>+#endif
> 
> /*
>  * mx6ul_14x14_evk board default supports sd card. If want to use
>-- 
>1.9.1
>
>_______________________________________________
>U-Boot mailing list
>U-Boot at lists.denx.de
>https://lists.denx.de/listinfo/u-boot