[U-Boot] [PATCH 06/17] mx6ul_14x14_evk: Fix unused variable warning

[Stefano Babic]

On 09/05/2017 04:14, Tom Rini wrote:
> The variable usdhc1_pads is only referenced during SPL builds, add a guard.
> 
> Cc: Stefano Babic <sbabic at denx.de>
> Cc: Peng Fan <peng.fan at nxp.com>
> Signed-off-by: Tom Rini <trini at konsulko.com>
> ---
>  board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c b/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
> index b28ce1049589..a5746fe08688 100644
> --- a/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
> +++ b/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
> @@ -225,6 +225,7 @@ static iomux_v3_cfg_t const uart1_pads[] = {
>  	MX6_PAD_UART1_RX_DATA__UART1_DCE_RX | MUX_PAD_CTRL(UART_PAD_CTRL),
>  };
>  
> +#ifndef CONFIG_SPL_BUILD
>  static iomux_v3_cfg_t const usdhc1_pads[] = {
>  	MX6_PAD_SD1_CLK__USDHC1_CLK | MUX_PAD_CTRL(USDHC_PAD_CTRL),
>  	MX6_PAD_SD1_CMD__USDHC1_CMD | MUX_PAD_CTRL(USDHC_PAD_CTRL),
> @@ -240,6 +241,7 @@ static iomux_v3_cfg_t const usdhc1_pads[] = {
>  	/* RST_B */
>  	MX6_PAD_GPIO1_IO09__GPIO1_IO09 | MUX_PAD_CTRL(NO_PAD_CTRL),
>  };
> +#endif
>  
>  /*
>   * mx6ul_14x14_evk board default supports sd card. If want to use
> 
Reviewed-by: Stefano Babic <sbabic at denx.de>

Best regards,
Stefano


-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================