[U-Boot] [PATCH v7 00/17] ARM: i.MX6: SabreSD: Add dts support

[Fabio Estevam]

Hi Jagan,

On Fri, May 26, 2017 at 2:28 PM, Jagan Teki <jagannadh.teki at gmail.com> wrote:

> OK, please rebase now, forgot to update this series changes.

The pmic command appears in this version, but I see other issues now:

U-Boot SPL 2017.05-00704-g16fa9ec (May 26 2017 - 14:30:16)
Trying to boot from MMC1


U-Boot 2017.05-00704-g16fa9ec (May 26 2017 - 14:30:16 -0300)

CPU:   Freescale i.MX6Q rev1.2 996 MHz (running at 792 MHz)
CPU:   Automotive temperature grade (-40C to 125C) at 38C
Reset cause: POR
Model: Freescale i.MX6 Quad SABRE Smart Device Board
I2C:   ready
DRAM:  1 GiB
PMIC:  PFUZE100 ID=0x10
MMC:   FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2
gpio at 020a4000: dir_output: error: gpio GPIO3_19 not reserved
gpio at 020a4000: set_value: error: gpio GPIO3_19 not reserved
gpio at 020b4000: dir_output: error: gpio GPIO7_12 not reserved
gpio at 020b4000: set_value: error: gpio GPIO7_12 not reserved

(These errors are new)

PCI:   pcie phy link never came up
No panel detected: default to Hannstar-XGA
gpio at 0209c000: dir_output: error: gpio GPIO1_21 not reserved
Display: Hannstar-XGA (1024x768)
In:    serial
Out:   serial
Err:   serial
Net:
Warning: ethernet at 02188000 MAC addresses don't match:
Address in ROM is          00:04:9f:02:70:67
Address in environment is  00:04:9f:02:19:a0
eth0: ethernet at 02188000
Hit any key to stop autoboot:  0
=> dhcp zImage
Read MDIO failed...
Read MDIO failed...
Read MDIO failed...
Read MDIO failed...
Read MDIO failed...
Read MDIO failed...
Read MDIO failed...

(Ethernet does not work anymore).