[U-Boot] [PATCH v7 00/17] ARM: i.MX6: SabreSD: Add dts support

[Jagan Teki]

On Fri, May 26, 2017 at 11:04 PM, Fabio Estevam <festevam at gmail.com> wrote:
> Hi Jagan,
>
> On Fri, May 26, 2017 at 2:28 PM, Jagan Teki <jagannadh.teki at gmail.com> wrote:
>
>> OK, please rebase now, forgot to update this series changes.
>
> The pmic command appears in this version, but I see other issues now:
>
> U-Boot SPL 2017.05-00704-g16fa9ec (May 26 2017 - 14:30:16)
> Trying to boot from MMC1
>
>
> U-Boot 2017.05-00704-g16fa9ec (May 26 2017 - 14:30:16 -0300)
>
> CPU:   Freescale i.MX6Q rev1.2 996 MHz (running at 792 MHz)
> CPU:   Automotive temperature grade (-40C to 125C) at 38C
> Reset cause: POR
> Model: Freescale i.MX6 Quad SABRE Smart Device Board
> I2C:   ready
> DRAM:  1 GiB
> PMIC:  PFUZE100 ID=0x10
> MMC:   FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2
> gpio at 020a4000: dir_output: error: gpio GPIO3_19 not reserved
> gpio at 020a4000: set_value: error: gpio GPIO3_19 not reserved
> gpio at 020b4000: dir_output: error: gpio GPIO7_12 not reserved
> gpio at 020b4000: set_value: error: gpio GPIO7_12 not reserved
>
> (These errors are new)

Yes, because of non-dm-gpio calls.

>
> PCI:   pcie phy link never came up
> No panel detected: default to Hannstar-XGA
> gpio at 0209c000: dir_output: error: gpio GPIO1_21 not reserved
> Display: Hannstar-XGA (1024x768)
> In:    serial
> Out:   serial
> Err:   serial
> Net:
> Warning: ethernet at 02188000 MAC addresses don't match:
> Address in ROM is          00:04:9f:02:70:67
> Address in environment is  00:04:9f:02:19:a0
> eth0: ethernet at 02188000
> Hit any key to stop autoboot:  0
> => dhcp zImage
> Read MDIO failed...
> Read MDIO failed...
> Read MDIO failed...
> Read MDIO failed...
> Read MDIO failed...
> Read MDIO failed...
> Read MDIO failed...
>
> (Ethernet does not work anymore).

Will fix, and get back.

thanks!
-- 
Jagan Teki
Free Software Engineer | www.openedev.com
U-Boot, Linux | Upstream Maintainer
Hyderabad, India.