[U-Boot] [PATCH 00/40] zynqmp: arm64: DT changes

[Michal Simek]

This patchset is updating zynqmp DT binding.

Thanks,
Michal


Anurag Kumar Vulisha (6):
  arm64: zynqmp: Add SMMU support for SATA IP
  arm64: zynqmp: Add reset-controller support in serdes driver
  arm64: zynqmp: Use reset controller framework for
    asserting/de-asserting reset
  arm64: zynqmp: Add support reading SoC revision using nvmem driver in
    dwc3
  arm64: zynqmp: Uncomment snps,quirk-frame-length-adjustment flag in
    dwc3
  arm64: zynqmp: usb: Correct IOMMU node for making SMMU work with USB

Bharat Kumar Gogada (1):
  arm64: zynqmp: zcu102: Modifying GTR lane-0 to PCIe

Chirag Parekh (1):
  arm64: zynqmp: Update device tree for gpio

Hyun Kwon (1):
  arm64: zynqmp: Update the GPU address size

Jolly Shah (1):
  arm64: zynqmp: Reduced min-residency time for idle state node

Jyotheeswar Reddy (1):
  arm64: zynqmp: DT: Fix typo in idle-states node definition

Jyotheeswar Reddy Mutthareddyvari (1):
  arm64: zynqmp: PM: Specify power domains for DP related nodes

Madhurkiran Harikrishnan (1):
  arm64: zynqmp: Add clock name for GPU

Manish Narani (3):
  arm64: zynqmp: sdhci: set host quirk2 for no 1.8V support for 1.0
    silicon
  arm64: zynqmp: Enabled CCI support for USB
  arm64: zynqmmp: Add USB OTG interrupts support in dt

Michal Simek (16):
  arm64: zynqmp: Add references to cpu nodes
  arm64: zynqmp: Fix broken architected timer interrupt trigger
  arm64: zynqmp: Add missing gpio property to dtsi
  arm64: zynqmp: Use revision in dts file description
  arm64: zynqmp: Add revB string to compatible string
  arm64: zynqmp: Add missing alias for gem0 for ep108
  arm64: zynqmp: Remove leading 0s from mtd table for spi flashes
  arm64: zynqmp: Use SPDX license with dc4
  arm64: zynqmp: Remove local-mac-address from dtsi file
  arm64: zynqmp: Update device tree for pinmux
  arm64: zynqmp: Add support for zcu102 1.0 rev
  arm64: zynqmp: Remove tx_termination_fix detection on silicon v1
  arm64: zynqmp: dt: Add AMS node
  arm64: zynqmp: Move nodes which have no reg property out of bus
  arm64: zynqmp: Remove clock setting from dtsi
  arm64: zynqmp: Add note about si5328 interrupt

Naga Sureshkumar Relli (1):
  arm64: zynqmp: disable smmu

Nava kishore Manne (3):
  arm64: zynqmp: Label whole PL part as fpga_full region
  arm64: zynqmp: rtc: Add calibration
  arm64: zynqmp: Add support for zynqmp nvmem firmware driver

Rob Herring (1):
  arm64: dts: xilinx: fix PCI bus dtc warnings

Shubhrajyoti Datta (2):
  arm64: zynqmp: Update the OPPs for cpu freq
  arm64: zynqmp: Enable watchdog by default

Soren Brinkmann (1):
  arm64: zynqmp: PM: Add IRQ

 arch/arm/dts/Makefile                         |   1 +
 arch/arm/dts/zynqmp-clk.dtsi                  |   2 +-
 arch/arm/dts/zynqmp-ep108-clk.dtsi            |   2 +-
 arch/arm/dts/zynqmp-ep108.dts                 |   5 +-
 arch/arm/dts/zynqmp-zc1751-xm015-dc1.dts      |   1 -
 arch/arm/dts/zynqmp-zc1751-xm016-dc2.dts      |   5 +-
 arch/arm/dts/zynqmp-zc1751-xm018-dc4.dts      |   9 +-
 arch/arm/dts/zynqmp-zc1751-xm019-dc5.dts      |   1 -
 arch/arm/dts/zynqmp-zcu102-rev1.0.dts         |  37 +++
 arch/arm/dts/zynqmp-zcu102-revA.dts           | 321 +++++++++++++++++++++++++-
 arch/arm/dts/zynqmp-zcu102-revB.dts           |   1 +
 arch/arm/dts/zynqmp.dtsi                      | 284 +++++++++++++++--------
 configs/xilinx_zynqmp_zcu102_rev1_0_defconfig |  75 ++++++
 include/dt-bindings/pinctrl/pinctrl-zynqmp.h  |  30 +++
 14 files changed, 653 insertions(+), 121 deletions(-)
 create mode 100644 arch/arm/dts/zynqmp-zcu102-rev1.0.dts
 create mode 100644 configs/xilinx_zynqmp_zcu102_rev1_0_defconfig
 create mode 100644 include/dt-bindings/pinctrl/pinctrl-zynqmp.h

-- 
1.9.1