[U-Boot] [PATCH v2 0/5] mmc: omap_hsmmc: Add support for ADMA

[Jean-Jacques Hiblot]

Hi Jaehoon


On 25/09/2017 07:26, Jaehoon Chung wrote:
> Hi,
>
> On 09/25/2017 11:15 AM, Simon Glass wrote:
>> Hi,
>>
>> On 22 September 2017 at 08:20, Jaehoon Chung <jh80.chung at samsung.com> wrote:
>>> On 09/21/2017 11:51 PM, Jean-Jacques Hiblot wrote:
>>>> This series enables the ADMA present in some OMAP SOCs.
>>>> On a DRA7 the performances when reading from the eMMC go from 18MB/s
>>>> to 43MB/s.
>>>> Also while were at it, fix some incorrect bit operations
>>>>
>>>> This series applies on top of the series that enables HS200 and UHS mode
>>>> "mmc: Add support for HS200 and UHS modes" but should be easy to use on top
>>>> of u-boot/master (just remove special handling of the tuning).
>>>>
>>>> This is the first series of 3 which wille enable HS200 and UHS on the omap5
>>>> platforms (dra7 and am57).
>>> I didn't have omap board...Can someone check this patchset with omap?
>>> Then it's more clearly.
>> Possibly, but it should not hold up the series being applied IMO.
>> People tend to test mainline and it's good to apply these sorts of
>> things during the merge window so that problems are found during the
>> RC period.
> This patch is depended on "HS200 an UHS modes" patches..
> but i have replied with the some comment for them..so i will not apply this patches before applying them.
Thank you for merging the "HS200 and UHS modes" series.

Will you take this series also ? and the series actually implementing 
the missing pieces HS200 and UHS for omap5 (mmc: omap5: Add support for 
UHS and HS200 modes​) ?

Thanks,

Jean-Jacques

> Best Regards,
> Jaehoon Chung
>
>> Regards,
>> Simon
>>
>>
>>
>