[U-Boot] [PATCH v4 1/5] spi: cadence_spi: Sync DT bindings with Linux

[Jason Rush]

Adopt the Linux DT bindings. This also fixes an issue
with the indaddrtrig register on the Cadence QSPI
device being programmed with the wrong value for the
socfpga arch.
---
Changes for v4:
   - Rebased

 drivers/spi/cadence_qspi.c     | 20 ++++++++++++--------
 drivers/spi/cadence_qspi.h     |  6 +++++-
 drivers/spi/cadence_qspi_apb.c | 15 ++++-----------
 3 files changed, 21 insertions(+), 20 deletions(-)

diff --git a/drivers/spi/cadence_qspi.c b/drivers/spi/cadence_qspi.c
index 9a6e41f..991a716 100644
--- a/drivers/spi/cadence_qspi.c
+++ b/drivers/spi/cadence_qspi.c
@@ -212,7 +212,7 @@ static int cadence_spi_xfer(struct udevice *dev, unsigned int bitlen,
 
 	/* Set Chip select */
 	cadence_qspi_apb_chipselect(base, spi_chip_select(dev),
-				    CONFIG_CQSPI_DECODER);
+				    plat->is_decoded_cs);
 
 	if ((flags & SPI_XFER_END) || (flags == 0)) {
 		if (priv->cmd_len == 0) {
@@ -296,7 +296,11 @@ static int cadence_spi_ofdata_to_platdata(struct udevice *bus)
 
 	plat->regbase = (void *)data[0];
 	plat->ahbbase = (void *)data[2];
-	plat->sram_size = fdtdec_get_int(blob, node, "sram-size", 128);
+	plat->is_decoded_cs = fdtdec_get_bool(blob, node, "cdns,is-decoded-cs");
+	plat->fifo_depth = fdtdec_get_uint(blob, node, "cdns,fifo-depth", 128);
+	plat->fifo_width = fdtdec_get_uint(blob, node, "cdns,fifo-width", 4);
+	plat->trigger_address = fdtdec_get_uint(blob, node,
+		"cdns,trigger-address", 0);
 
 	/* All other paramters are embedded in the child node */
 	subnode = fdt_first_subnode(blob, node);
@@ -310,12 +314,12 @@ static int cadence_spi_ofdata_to_platdata(struct udevice *bus)
 				       500000);
 
 	/* Read other parameters from DT */
-	plat->page_size = fdtdec_get_int(blob, subnode, "page-size", 256);
-	plat->block_size = fdtdec_get_int(blob, subnode, "block-size", 16);
-	plat->tshsl_ns = fdtdec_get_int(blob, subnode, "tshsl-ns", 200);
-	plat->tsd2d_ns = fdtdec_get_int(blob, subnode, "tsd2d-ns", 255);
-	plat->tchsh_ns = fdtdec_get_int(blob, subnode, "tchsh-ns", 20);
-	plat->tslch_ns = fdtdec_get_int(blob, subnode, "tslch-ns", 20);
+	plat->page_size = fdtdec_get_uint(blob, subnode, "page-size", 256);
+	plat->block_size = fdtdec_get_uint(blob, subnode, "block-size", 16);
+	plat->tshsl_ns = fdtdec_get_uint(blob, subnode, "cdns,tshsl-ns", 200);
+	plat->tsd2d_ns = fdtdec_get_uint(blob, subnode, "cdns,tsd2d-ns", 255);
+	plat->tchsh_ns = fdtdec_get_uint(blob, subnode, "cdns,tchsh-ns", 20);
+	plat->tslch_ns = fdtdec_get_uint(blob, subnode, "cdns,tslch-ns", 20);
 
 	debug("%s: regbase=%p ahbbase=%p max-frequency=%d page-size=%d\n",
 	      __func__, plat->regbase, plat->ahbbase, plat->max_hz,
diff --git a/drivers/spi/cadence_qspi.h b/drivers/spi/cadence_qspi.h
index d1927a4..8315421 100644
--- a/drivers/spi/cadence_qspi.h
+++ b/drivers/spi/cadence_qspi.h
@@ -18,14 +18,18 @@ struct cadence_spi_platdata {
 	unsigned int	max_hz;
 	void		*regbase;
 	void		*ahbbase;
+	bool		is_decoded_cs;
+	u32		fifo_depth;
+	u32		fifo_width;
+	u32		trigger_address;
 
+	// Flash parameters
 	u32		page_size;
 	u32		block_size;
 	u32		tshsl_ns;
 	u32		tsd2d_ns;
 	u32		tchsh_ns;
 	u32		tslch_ns;
-	u32		sram_size;
 };
 
 struct cadence_spi_priv {
diff --git a/drivers/spi/cadence_qspi_apb.c b/drivers/spi/cadence_qspi_apb.c
index e02f221..8309ab8 100644
--- a/drivers/spi/cadence_qspi_apb.c
+++ b/drivers/spi/cadence_qspi_apb.c
@@ -37,10 +37,6 @@
 #define CQSPI_REG_RETRY				10000
 #define CQSPI_POLL_IDLE_RETRY			3
 
-#define CQSPI_FIFO_WIDTH			4
-
-#define CQSPI_REG_SRAM_THRESHOLD_WORDS		50
-
 /* Transfer mode */
 #define CQSPI_INST_TYPE_SINGLE			0
 #define CQSPI_INST_TYPE_DUAL			1
@@ -51,9 +47,6 @@
 #define CQSPI_DUMMY_CLKS_PER_BYTE		8
 #define CQSPI_DUMMY_BYTES_MAX			4
 
-#define CQSPI_REG_SRAM_FILL_THRESHOLD	\
-	((CQSPI_REG_SRAM_SIZE_WORD / 2) * CQSPI_FIFO_WIDTH)
-
 /****************************************************************************
  * Controller's configuration and status register (offset from QSPI_BASE)
  ****************************************************************************/
@@ -400,7 +393,7 @@ void cadence_qspi_apb_controller_init(struct cadence_spi_platdata *plat)
 	writel(0, plat->regbase + CQSPI_REG_REMAP);
 
 	/* Indirect mode configurations */
-	writel((plat->sram_size/2), plat->regbase + CQSPI_REG_SRAMPARTITION);
+	writel((plat->fifo_depth/2), plat->regbase + CQSPI_REG_SRAMPARTITION);
 
 	/* Disable all interrupts */
 	writel(0, plat->regbase + CQSPI_REG_IRQMASK);
@@ -560,7 +553,7 @@ int cadence_qspi_apb_indirect_read_setup(struct cadence_spi_platdata *plat,
 		addr_bytes = cmdlen - 1;
 
 	/* Setup the indirect trigger address */
-	writel((u32)plat->ahbbase,
+	writel(plat->trigger_address,
 	       plat->regbase + CQSPI_REG_INDIRECTTRIGGER);
 
 	/* Configure the opcode */
@@ -659,7 +652,7 @@ int cadence_qspi_apb_indirect_read_execute(struct cadence_spi_platdata *plat,
 		bytes_to_read = ret;
 
 		while (bytes_to_read != 0) {
-			bytes_to_read *= CQSPI_FIFO_WIDTH;
+			bytes_to_read *= plat->fifo_width;
 			bytes_to_read = bytes_to_read > remaining ?
 					remaining : bytes_to_read;
 			readsl(plat->ahbbase, bb_rxbuf, bytes_to_read >> 2);
@@ -710,7 +703,7 @@ int cadence_qspi_apb_indirect_write_setup(struct cadence_spi_platdata *plat,
 		return -EINVAL;
 	}
 	/* Setup the indirect trigger address */
-	writel((u32)plat->ahbbase,
+	writel(plat->trigger_address,
 	       plat->regbase + CQSPI_REG_INDIRECTTRIGGER);
 
 	/* Configure the opcode */
-- 
2.1.4