[U-Boot] mtd: cfi: Add support for status register polling

[Marek Vasut]

On 11/17/2017 08:02 PM, Marek Vasut wrote:
> On 11/17/2017 05:43 PM, York Sun wrote:
>> On 09/12/2017 10:09 AM, Marek Vasut wrote:
>>> The status register is optional in the AMD command sets, but it's
>>> presence can be checked by reading out CFI table entry 0xc bit 0.
>>> If the register is present, prefer using it's bit 7 to determine
>>> if the flash is busy over reading the flash ; this is needed ie.
>>> on Hyperflash memories.
>>>
>>> Signed-off-by: Marek Vasut <marek.vasut+renesas at gmail.com>
>>> ---
>>
>> Marek,
>>
>> Some of our boards failed. I traced to this commit. Reverting this
>> commit fixes the issue. I happen to have two boards with slightly
>> different flash chip. One works and the other doesn't.
> 
> I can't since I don't have the board with such a chip ...
> Which chip is that ? Mine is Spansion S25KL256 hyperflash.

S26KL256S (26 instead of 25), sorry.

> 
>> The working board has
>>
>> => fli
>>
>> Bank # 1: CFI conformant flash (16 x 16)  Size: 128 MB in 1024 Sectors
>>   AMD Standard command set, Manufacturer ID: 0x01, Device ID: 0x227E2801
>>   Erase timeout: 2048 ms, write timeout: 1 ms
>>   Buffer write timeout: 3 ms, buffer size: 512 bytes
>>
>> The failing board has
>>
>> => fli
>>
>> Bank # 1: CFI conformant flash (16 x 16)  Size: 128 MB in 1024 Sectors
>>   AMD Standard command set, Manufacturer ID: 0x01, Device ID: 0x227E2801
>>   Erase timeout: 4096 ms, write timeout: 1 ms
>>   Buffer write timeout: 3 ms, buffer size: 64 bytes
>>
>> Can you investigate?
>>
>> York
>>
> 
> 


-- 
Best regards,
Marek Vasut